开云体育

Hi, Well then I must be stupid ... Next time I will do a screen shot of the error GCC is giving me ... ? Have you made after centering the object an " Additional Align " command ? Of course the

Not to hijack and off topic thread but SBIG has a wireless ethernet setup? Wow I could image from indoors Dave

I have forced a meridian flip several times on my Titan and whatever it was tracking is remembered and close to centered after the flip. i was doing M81 last night and was approaching the safety point

P.S. There is also a built in serial command to do the meridian flip. Which is the MF# and MM#command. This command is the same as in the Gemini 1 Tom Hilton

Felipe Since it is intended that the Gemini 2 will have all the features of the Gemini 1, I would expect it to also have the meridian flip command. The Gemini 1 already has a meridian Flip command.

Hola Felipe, Well what I am talking about is a complete different think as what you are asking. You want to have an automatic meridian flip which could be invoked at a certain altitude angle which I

Hi Rainer Don't be sorry. Your're posts are always welcome. I was making the suggestion, hoping that someone could help you figure out what is causing the problem. I noticed that Ren??? posted a

Hi Rainer .. thank you for raising the issue "Meridian flip" because I did a question in the forum and have not had any response . I will think about it much to buy the new Gemini II if the topic

Hi, Sure you are right. That is a mistake we all do thinking that everybody has or uses the same as we do :-) I brought this up here so maybe it can be changed. I brought this issue up a few years

Hi Rainer PS you might want to tell them up front that you do not use any ASCOM based program or theSky6 or TheSkyX. That way you will not get replies such as Floyd's because they will have this

Hi Rainer Could I suggest that you also post what is going on with your Gemini 1 units on the Gemini users group. There are a lot more users over there that might be able to give you some incite

Hi Floyd, OK, I understand, but please understand that not everybody has CCD Auto Pilot for making a plate solve, not everybody has as well as The Sky Pro 6 and not everybody works with ASCOM, ? OK

I just let CCDAutoPilot Plate solve after the flip, using Pinpoint and The Sky 6 Pro, it then is right on targer. But, I never really have any issue after a flip finding a star or object. Floyd

Phew, I'm off the hook then as my serial port is blown on my Gemini so I can not use GCC Regards Badger

Hi, Well I would say, please try the following: Get a star in a position with which you can do a Meridian Flip. Do an additional align ... then do a Meridian Flip ... after the Meridian Flip center

Hola Rainer I was surprised that you asked that question given your long history with this mount, the short answer is that Gemini does know which star you did a flip on, this is demonstrated by the

Hi, I am sitting in the observatory and just detected in Gemini I the following: Align on a Star > Do a meridian Flip and Gemini I does not remmber on which object the meridian flip was done. So

Ok Tom, I will read it.. Thanks! Miguel Enviado desde mi iPhone

Tom, I have done a ping to the IP of Gemini and I have not received response...? I'm in the Canary Islands... Regards Miguel Enviado desde mi iPhone

Miguel and Andrew. The default on the Gemini is DHCP after programming the flash memory of the processor. But after 4 seconds, it defaults to static with an address of 192.168.0.111 If his computer