开云体育

Mike Thanks for the response, I've never had to ferrite a radio before, but since I was smart enough to ask before doing the install, can you make suggestions for the ferrites, depending upon the

Interesting concept, never though of doing that. How do you attach the wires to the magnets? Richard. W9LGH

R Been there and done that in my wife's 07. Connected directly to the 12v battery in the trunk. Here is where you might run into some limits. Don't be shy about RFI resistance in the vehicle. Put

Hi BobLook at my QST article, 2010 January page 46 for mounting the Yaesu ATAS antenna on a magnetic mount.? ?The secret to using a magnetic mount with an ATAS is running ground wires to the

Finally getting around to doing an install in my 2010 Prius, I know discontinued radio for a 10 year old car. I have the separation kit, and an ATAS-120, and a Comet mount, debating between the Comet

I had to advise an electrician that the reason the accelerator or gas pedal cable and the choke cable caught fire was; The engine is mounted in the engine bay on rubber vibration mounts to

"Compton" <comptonallen@...> wrote: That only applies if you are ging to somehow try and bridge engine block and chassis using your radio Negative fuse is pointless Pete

No, but in Spain? the yaesu representative don't sale direct to the end user.? I try across hers local distribuitors. Thanks for your help

Tuner is off but I found the problem. ?Somehow I had gotten into the multifunction MFq and key C turns on/off a 2 sec tone of 1750 for ATC. Don’t understand all this yet but tone is gone. Happy me.

well done… Jack W4GRJ Sent: Friday, May 08, 2020 2:15 PM To: [email protected] Subject: Re: [FT-857] Another look at the Yaesu FT 857D I plead guilty as charged , however, on more

I plead guilty as charged? , however, on more serious side - how does "HASH words" taste ? Is is close to "SPAM" ? ( as is by now this post ) But I just could not help (try) to poke some fun. I is

Loosely quoted from manual " a carrier signal will be send to setup autotuner....". Did not find an actual frequency of the tuning signal, but sure sounds like you have autotuner activated. I believe

It almost sounds like wires-x is enabled, like on the FT-8800. But as far as I know, the 857 doesn't have wires-x functionality. 73, --Hank KB4MTO / TA5ZC https://www.hamradio.hanklambert.com

I’ll check that this pm. The tone only last for 2-3 seconds and turns off.

1500 khz repeater tone may have been activated by mistake? --------------- Regards, Tony VA7TF VE7ACF Sent: May 6, 2020 4:58 PM To: [email protected] Subject: [FT-857] 857D on FM My 857 transmit

Respectfully disagree - even dubious values discussions are better then just say "o well ... put it in bed ". Some replies are rather typical - difference of opinions and expressions? are emphasized,

It would be nice to continue TECHNICAL discussion without commentaries such as this "Its not unusual for many to not understand this and why." In the spirit of learning and not preaching , if I may

My 857 transmit a tone when first pressing the mic to key. ?I recently removed the ATIS 120 antenna and installed a Tarheel 100 with a TuneMatic for HF. A separate 2 M/440 antenna was installed got

I agree completely!! ?John, KK4QFP? ~Don’t let the old person in~

Can we put this thread to "Bed". Don WA7GTU