开云体育

Hi, All, I like my FT-897 very much, but most of my ham operation in future is likely to be mobile, and so I could better use the smaller size and lesser weight of the FT-857. Is there anyone in the

Set menu 038 to "USER-U" and mode to to "DIG" Jeremy VO1JEZ

Can you share them with me im setting up for FT-8 also thanks in advance KB1QDC Kev... KB1QDC@...

Hello folks, New to the forum. I just purchased the FT-857D and did the frequency expansion mod to see what this radio could do on the bench. What is interesting is, when putting the radio on a dummy

Please share your settings. Thanks. 73 W5WMM

I am up and running. Reach out to me over the weekend and I can go over the settings wit you. 73 WV2C

Yes, thank you. Douglas Wyman was kind enough to remind me. That is what I get for attempting to go straight from memory instead of visiting the manual before posting. I do vividly recall that for the

Actually the brown wire is a battery sense. It changes the power out to conserve battery when it is energized. The atas120 is controlled by a dc voltage imposed on the coax line. Less than

The brown wire when connected to ground reduces output of the 857D to 20 watts automatically. KA2HPG

I believe that the ATAS-120 and the FT-857 both need to be grounded to the same potential.? ?There is a 3rd, brown wire for the power connector on the FT-857 which, if I recall, serves the purpose

I also have a Japanese 857 on my hands. Were you able to open tx for repater use and open up the upper segment of V/H for TX? I did mod it with the well know configuration, but no luck.I do realise

Old thread. I also have a Japanese FT-857. The MARS mod 888I88III does not unlock anything. Actually removing the zero ohm resistor at at position 3 (fornt front to back) makes me loose WIDE RX on

Do you have a programming cable hooked to the radio? I had this problem and found it to be the RT systems programming that was connected to my radio. Unplugged the cable and the PL tone frequencies

Yes that seems to be my best fix for now. Thank you...Tony

Hi Tony, If you have the ability to restore the programmed frequencies easily I would do a factory reset and reprogram the frequencies and see what you get. Any chance that the repeaters input pl tone

For some reason now, my PL frequency is off by one setting. So, for example, on both 2 meters and 450mhz if I want to transmit using a PL of 114.8 I must tune to a PL freq of 118.8 to key a repeater

I finally got it to work. Here are my settings below. I am using a SignaLink USB interface and an RT systems interface cable for CAT control. Ryan WG4I FT-857@...> wrote: [Non-text

If we are speaking of the protocol settings for the cat connection for the FT-857 & 817, I do not think that there are any that work. The correct settings, as tested successfully with various other

I’d be interested myself. I suspect they be the same for the FT817 as well Ralph WA2QYA

Did anyone ever figure out the settings for the 857 using a SignaLink and WSJT-X ? Ryan WG4I FT-857@...> wrote: