开云体育

I have done the required calculations and meet the requirements. Nevertheless I tend to agree that it is the direct exposure you refer to. Come nicer weather I may switch to a different antenna that

ohhhhh, that would be a good one! I'd vote for that too. LOL 73,

If your problem is not uncontrolled common mode RFI, it is direct RF Exposure. If direct RF Exposure is causing your problems, you are probably in violation of part 97.13 (c). Have you

I’m still waiting for the “enable coffee pot on rare DX” interface ? 73, Ken, KJ9B Sent: Tuesday, March 4, 2025 9:30 AM To: DXLab@groups.io Subject: Re: [DXLab] Band spread One

One more question....is there anything your software won't do? :) take care 73,

I put on toroids on all things that enter the PC. I have followed many thigs to try to get good ground system . I HAVE NO PROBLEMS WITH ANY OTHER PROGRAM BUT WINWARBLER IS USELESS ON 20m AT > 300

+ AA6YQ comments below + The 4th paragraph of https://www.dxlabsuite.com/dxkeeper/Help/SortLog.htm + suggested using the ABS function, applying it to the DXCCID field as an example. I changed this

Joe, good tip! The val(Band) works fine. Thank you Lui

# more AA6YQ comments below + If you make the Needed column visible in the Spot Database Display and can remember the abbreviations, you'll be able to immediately see why a Spot Database Entry is

Awesome Dave! Thanks so much for the tip. I'll add that to the display. That will be very handy. 73,

+ AA6YQ comments below AHA! OK, I think I have it. I just had a great example. 2 spots for VK9XU on 28.095. One is black and one is red. the black one is FT8 and the red one is RTTY When I check

AHA! OK, I think I have it. I just had a great example. 2 spots for VK9XU on 28.095. One is black and one is red. the black one is FT8 and the red one is RTTY When I check the award status the

Hi Dave, I realize that. But it's being flagged red even though I've already worked it on one of the other digital modes. This isn't happening in reverse. I've seen spots for FT8 stations that I

To answer Joe, I have SC Filter selected and nothing is in it. I think what I wanted to try was unclear. I'll try to describe it better. It's not that I don't want to see the spots that come in as

Hi Dave & Joe, To answer Joe, I have SC Filter selected and nothing is in it. I think what I wanted to try was unclear. I'll try to describe it better. It's not that I don't want to see the spots

Perhaps the OP made a typo and meant FT8 rather than FT9? JT65 and JT9 were popular JT modes when I became a ham 10 years ago. 73 Stan KM4HQE

Don, Are you using a filter in Commander -> Config -> BandSpread -> Spot Filter? If so, which filter and what is in it? I'd bet you have defined one that specifies Mode='RTTY' ... you will want to

+ AA6YQ comments below Currently my bandspread will highlight anything I need on RTTY. I don't use RTTY anymore and primarily use FT8 as my digital mode. Is there a way to get the bandspread to

Thanks Joe, That appears to also work. Jim - KR9U

Hi Dave, Currently my bandspread will highlight anything I need on RTTY. I don't use RTTY anymore and primarily use FT8 as my digital mode. Is there a way to get the bandspread to only highlight