开云体育

At $59, I consider this a kit that just happens to have most of the parts already soldered?to the board. ?Some assembly required. ?Batteries not included. ?Those upset about not finding?name

Good that you are moving to the CLK0 BFO scheme, looking forward to that. ?Once both BFO and VFO are generated from the Si5351, then all errors in operating frequency are proportional to the error in

Hi All, I had an issue with one knockoff nano on one computer (hard to recall the combination of the two but the board was not recognized by the computer/IDE) and following the procedure laid out

They are Spanish language hams. Miami? Mexico? I don't know.

have you tried to adjust the blue trimmer on backside of Raduino, it is contrast

I've been using Nano clones for years and have never had an issue. Is the clone causing an issue? If it is, you can always cut out/desolder the cheap socket, buy a "real" Nano and a quality socket,

Does "blank" mean no light at all from the display, or that the display lights, but no letters appear? Jack, W8TEE To: [email protected] Sent: Thursday, May 25, 2017 8:18 AM Subject: [BITX20] Dead

greetings bitx40 users; ? ? ? ?Unit receives both SSB and CW. Red LED lights up between raduino board and display board however display screen is deat (blank). A friend and I believe the display

For what it's worth, my board seems to be fine.? It's detected by Linux, and I was able to install the new firmware on it without difficulty. Now I just need the rest of my parts so I actually

Are these "kilowatters" ham stations? Or are they images from SW broadcasters higher up in the band? Here in Europe, with the BITX40, we can hear a lot of images from SW broadcasters transmitting in

Totally true Darren. The Nano clone even uses a different serial to USB chipset - CH340/CH341 which is an issue when using Arduino on OSX. 73 Dan HK4DEI

Interesting.? I would think that could be used to supplement one of the other methods rather than being a stand-alone way of learning code.? You need to be able to recognize individual characters,

Really?? It's not a genuine Arduino??? That's a little disappointing if it's true. -- Darren W9ZIM

Hi I am using a Diamond Speaker/Mic with a 4 way jack pin. Ground, PTT/MIC, Clone and speaker. The Bitx40 has 2 wires for speaker, 2 for Microphone and 2 for PTT The Speaker connected to Speaker pin,

Terry, sorry, you're not completely right. See the following picture, I've added some extra labels to avoid any confusion: 73 Allard PE1NWL

Terry. The socket on the Raduino is a mini USB as people have said but, as the arduino board on the raduino is a cheap clone it’s a poor quality socket. The fit on mine was VERY tight and also the

The cap helps clean the noise created by the wiper movement in the pot and the clean resistance vale is applied to the Arduino. terryhugheskirkcudbright@...> wrote: -- Regards Sarma

hi thanks for the link but they do not ship to uk terry

This is what you seek http://tinyurl.com/n5y6db4 v/r Fred W4JLE Sent: Wednesday, May 24, 2017 21:19 To: [email protected] Subject: Re: [BITX20] usb cable The USB cable needed is Mini, it has triangle

hi on the eight pin connector some of the pins are used for cw functions eg a0 brown is ptt sense a1 red key a2 not used a3 orange function button a4 yell, a5 green, a7 violet tune pot a6 not used