开云体育

Does anyone have a design for a sbitx case without a display? I have no need or want a display, I will use a monitor and keyboard. Or I'll use headless with my ipad. Post any pics or designs you

Pretty great system. Lots to learn and lots to love! Thank you guys for all of your hard work -- '72 Aaron K5ATG ( http://k5atg.com )

Wow! I'm really enjoying this new feature. I haven't tried the others yet but I'm sure they are great. Thanks JJ and team. Joel N6ALT

Jeff, yes it is now working as expected. I deleted *12,* in config.txt, then *Ctrl-O* <Enter> and finally *Ctrl-X* <Enter> to exit. After restarting, the indicator LED did not light up, only when I

You are right about K3 Evan Missed that out as I was writing the answer around 23:30. Regards Lawrence gmail.com@groups.io> wrote:

Release Announcement: We are excited to announce the release of software version 4.1 for the sBitx HF amateur radio transceiver! This release represents a major step forward, with numerous

Gyula recently uncovered an issue when using the QRO option. ?A few of you have purchased my QRO boards and will want to do a quick easy fix. ?It turns out that there is a configuration setting

No band decoder planned by our team.. -JJ

K3 switches the LPFs out of the receive path, so it is unlikely that any of the LPF circuits are the issue. As Scotty R. suggested, I would look for a possible heat issue.? This could be in any

First of all is this happening on all frequencies or on particular band or bands? If on a particulat band or bands using the same TX LPF then the respective LPF relay is suspect. If on all bands

Hi guys!! Have any of you have a band decoder to the sbitx?? Any ideas? Im doing a project and the amplifier uses3 lines for the lpf control. Before changing the software I would like to know if

Also, as a past RadioShack repair technician, I would like to suggest a can of freeze spray and a TINY heat torch to assist with troubleshooting poor connections and heat related failures. Many times

I had a similar experience, but the problem was not with the radio. It was a poor solder joint at the antenna. Once I would transmit the problem would go away then start to fade until I would key the

Last night I was thinking about it and I believe the first thing I'll try is cold spray. A bad solder joint could be the problem and cold spray sometimes reveals those. Possible bad relay noted...

You really have to scratch up these old memories. the same thing applies to the contacts for the Vibroplex Bug Brown Paper worked best as t was a little more coarse. Change out the relay take the old

Aha, before shortening/bypassing You can try open the radio and delicate knock K3 and K1 relays with screwdriver or similar tool. Sometimes phenomena/failure reacts on this - then You can be 99% sure

the traditional way to clean relay contacts depends on being able to carefully pry the plastic case off. Usually this can be accomplished. May require small "jeweler' " screwdrivers. Then take a

Hello, I will not write too much more than previous colleagues - I also would start checking relays. Yes, relays. RX path goes through TWO relays K3 and K1 (type HFD27/012-S relay). By default RX path

A dirty relay was my first thought, but the fading doesn't seem consistent with that. I'm just getting started with the problem. I have a fairly complete test equipment suite. Once I get inside I'll

JP Let's try what you have. Often the receive preselected is forgiving. Don't initially solder it flush, maybe on a couple leads. If your jukebox part doesn't have enough capacitance, put a small