开云体育

In case it wasn't obvious, there was a typo. The second range should have been V3 and V4 and *NOT* V3,V4,V5 as stated above. 73 Mark -- AJ6CU KD8CEC 2.0, Nextion Screens,? and open source uBITX

Open a terminal and do a sudo nano ~/sbitx/data/hw_settings.ini edit. Play with the “scale” coefficient up or down 20% and save. Restart the sbitx process. Start at Drive=50 and increase to 100 if

Evan, You will have to hand edit the hw_settings.ini. open it in a text editor and reduce the scale settings for 3.5 mhz by about 20%. Save the ini file and restart sbitx. See if the output power is

CEC V1.200 for version 2,3,4 Again, tnx fer your help. Nick - N4CL

Hi, 2019 I got the V5 uBITX - Suddently made enhancements - nextion Display - CEC Firmware - AGC, Audio CW Filter - Audio Amplifier, AUX connection for FLDigi waterfal Try now to make a new

cloyesjn, What software are you using?? Vic pointed out that the 4.3 version of the HFSignals code changed to transmitting a 10MHz signal when put into calibration mode.? That is not the case for

Where do you set the power levels for each band on a V1 DE running V2 software?? I have tried the default_hw_settings.ini and the hw_settings.ini files, and neither affects the power output.? I also

When i push the momentary switch, the TX light goes on and stays on until I exit the menu system and I hear a relay engage?? Would a relay engage on a final oscillation? .? I tried the dummy load

If you’ll give me your call sign I’ll check it out. 73

Thanks. I don't use my scope much anymore so it's time to blow the dust off it.

Thanks, I'll do it.

Vic, Wow, I totally forgot about that discussion.? I guess I am getting old and starting to lose some mental abilities.??Thank you for pointing that out.? It seems that there were two versions of

<grin> Evan, we've had this conversation

Thank you Rolan, see my reply to Evan. 73, Yvon AE7YD

I did flash it with the N8LOV and that is when the other problems (USB/LSB) started. I did the BFO calibration with no problem. The Frequency calibration was very close but then it went totally off.

The sBITX version 2 sounds like a great rig on paper and I would very much like to buy one, but this forum is such a mish mash of overlapping issues poorly identified that it is very difficult to

Here is something I ordered from Amazon. It comes tomorrow so I cannot say it is right or not? I measured the bitx and it seems like this will work? adada Hard Travel Case Fits Canon PIXMA TR150 /

Hi Mark, I like the bit about the xyl ''being away'' when the cat's away the dogs will play !! Know what you mean.. Yes, whenever you are ready I would certainly like a hex file.. catch you

Hi Bruce, Since you have a 'nice scope', use a 50 ohm dummy load and your in business.? Just measure the Peak voltage (Vpeak).? Power = (Vpeak^2)/100 Rgds, Gary

Evan, your note solved my problem. I didn't have to go into the source code, but when you mentioned that "an HDMI monitor without sound did not have the issue" I went to the monitor's controls (I'm