开云体育

Dear Dean, On the other? PTO stl files I had to increase the part by 10% on all dimensions.??? Now the nuts fit perfectly.?? In CURA you can arbitrarily increase or decrease a parts size by a

Pete - exiting the sbitx application and stopping fldigi, then restarting sbitx will often make the ?? question marks go away.While sbitx is running, use Alt-Tab to switch over to fldigi to see if the

On second thought, I'm not sure I am correct as it seems hard to make it decode under either code with much reliability. So please disregard until you have nothing better to work on. ;-) My internal

put it in clear epoxy and sell it as modern art?!? dg9bfc sigi Am 03.09.2022 um 16:15 schrieb barry halterman:

Good day Goody, Just want to report that under the latest and current version of your code the CW decoder does not work. Just lots of random letters and ? marks no matter how carefully I tune. I

Thanks Howard

Try this one?Bourns PEC11R-4020F-S0012?Mouser has plenty in stock, only $2.68 each. Max KG4PID

Want to trade? I'm serious. Mine is smooth but I think I'd like one that has the detents. My hands shake a lot and I have a hard time sometimes getting the frequency I want. There was a Bourns

Glad to hear, David. I just picked up a second one an am trying some other mods - minimally a Sotabeams DSP to see how it compares to the Hi-Per-Mite filter. ?The DSP has an LED for when you are in

Brian, yes. I have been thinking that I might have a bad J310. Ashhar, here are some readings from my build. The VFO RF voltage into the first mixer is 2.4Vp-p. Disabling the first makes no difference

I just got a second uBitx V6 and unlike my earlier one, the encoder has steps. Any suggestions about a smooth encoder replacement? ?I don't need the push switch as I'm using N8ME firmware. Tnx 73

Dean, looking good.. If you seem to have some extra play between the screw and nut, wrap the screw with a layer of Teflon pipe thread tape. It takes some of the wobbling out. Sent from Mail for

*How to Easily Create Desktop Shortcuts on Raspberry Pi OS? * https://raspberrytips.com/desktop-shortcuts-on-raspberry-pi/ -- Gyula HA3HZ

Scaling up by 10% worked perfectly.? Nice snug fit - easily able to insert the nut with fingers. Now to wind it up and test! 73, Dean KK4DAS

It could also be a faulty J310 (ESD damage??). Years ago when when JFET's were the latest, I built a transceiver that was lots of noise and weak signals. Years later I pulled the transistors to use in

Can you check: 1. What is the Output RF voltage peak2peak at the bfo output. 2. Can you monitor the 5MHz bfo on another receiver. Is that clean? [email protected]> wrote:

Barry, Your build far far more elegant than mine! The point of ugly construction is that it is beautiful in its own cramped, colourful, organic way. It is like a Van Gogh. The elegance of the ugly

Dean, Definitely right on that Morse code interpreter. Didn't even try to understand it. I ignored the code, fixed a couple 16 vs 32 bit integer problems (Nano's are 16bit integers, newer processors

Howard, Thank you for posting the link to your webpage on the v6.? I just received the v6 kit, and your write-up on CW is exceptionally helpful! 73, David

Aaron, If you're looking for someone to make the PTO form because you don't have a 3D printer try JLPCB ( jlpcb.com ), I had 4 made for me for $3.96 + $3.69 ($8.65 total) shipping by Global Direct to