I agree.. Didn't realise you wanted to convert to SMDs.. Recreate the PCB.. and the best place to start is with a schematic.. which would give a reliable and correct NETLIST..?
On Mon, Sep 20, 2021 at 11:21 AM Gerard <
kabupos@...> wrote:
Hello,
The dimensions are good. For me it is about 150mm side (6*2.54).The components are mounted on the layer where there is the most copper. For me the layer 1.
However, I can¡¯t seem to do what I wanted to do, which was to replace the components with SMD's.After redoing the diagram in Kicad and importing the components on this pcb, you cannot change the skillscreen layer (seen as a graphic layer).We should recreate the pcb from A to Z.
So I am also looking forward to the kicad documents of the ubitx v6.
cdt
Will Coetzee