开云体育

Harbor Freight does it on their 44991 Mini Mill, + a small fan as well

It will take longer if no helper is present, it takes just as long for the heat or cold to permeate in either direction, an A/C or heater will go as fast as it ever did... 5000 BTUs window A/C or

On my lathe The bottom is open by? design by manufacturer.? As long the chip do not jump high it will work . My lathe is a 2023 model maybe they working on over heating . It is to hot for

Here is one! 355848246324 for sale | eBay <https://www.ebay.com/sch/i.html?_from=R40&_trksid=p2332490.m570.l1313&_nkw=355848246324&_sacat=0> not mine Good Luck to any bidders!

I like cooling fans. Even inside point at board like do for computer's. Motors that are TEFC have fan inside and a fan out side to cool the motor.? Sometimes uses a aluminum end cap fir better heat

I added a computer fan to mine.

Speaking of heat, some of you might be interested in a modification I made to my minilathe about 15 years ago. To keep the electronics from overheating, I drilled holes in the cover with screening on

And once the inside gets hot, it takes longer to cool it down, as the insulation keeps the heat in ralphie [email protected]> wrote:

Victorville ,ca. area, 111 outside,,77 in insulated garage r-12 walls,6" spray foam against roof ply-exposed trusses ( 700 sq. ft.floor area), 12000 btu window unit(winter sale closeout $200.00) cut

When into my hobby shop and was 114° it insulated R13 walls ceiling R30. My wife and doctor does want working hot weather so put some of my projects on hold till getting cooler. At less paint dries

Yea, just a few degree cooler here in visalia. But still hot enough to melt things. Sunday will be 113. george

I was wondering why fleeling Hot Check tv . No one is letting run my mini lathe.

I’d still have a crack at fixing the holder, you’ve nothing to lose but a bit of time. Bend it back, use 2 pieces of wood to align it with the other one and put a clamp on it. Then add some

Thanks Jon! [email protected]> wrote:

Ralph, . Let me check it out, I never ran it. I'll let you know. . John

That would be a lot simpler for me! Do you use Paypal? Ralph Hulslander 225 Old Canoe Place Road East Southampton, NY 11968 [email protected]> wrote:

Ralph, I have that exact motor. Got it off of eBay in 2016 for $80 Let you have it for the same in 2024 ? $80 in 2016 = $105 in 2024 today my loss is your gain. I never needed it apparently, take it

Here is the Lathe <https://photos.app.goo.gl/AcZiu7uQ65HWdf1z8> I believe it is a Cummins. Here is the motor <https://photos.app.goo.gl/hDVDnD71MUVw4Noc8> [email protected]> wrote:

The brush holder is heat deformed. I will check the bearings. Ralph [email protected]> wrote:

That brush mount looks trashed, from way too much heat.? Contact Little Machine Shop, maybe they can sell you just the housing.