开云体育

Hi I am using the YCCC SO2R Box for audio? routing for my remote station.? Without contest software, just using the SO2R utility.? Turns out that choosing STEREO on the SO2R Box utility

That fixed the issue. I wish I would have thought of that before bothering you. Bill, N0AC

When Logger controls keyer is checked the logging program can change the keyer type. Uncheck it and make sure that Straight is selected. Paul, K1XM [email protected]> wrote:

Box is 1.11.1 and 1.6.0 Yes, logger controls keyer is checked. Bill, N0AC

What version of the SO2R Box software and firmware are you using? You can find this by clicking on the icon in the upper right corner of the window and selecting "About SO2R Box...". Do you have

In the SO2R box utility I select straight key from the keyer type menu and both rigs will work with my bug. When I launch the SO2R box app the straight radio button is selected in the keyer menu.

Dennis- I got it working with the help from Paul.? He notice that I had the so2r box talking to itself and N1MM talking to itself. I just had to change to com ports up so that they would talk to each

Dennis- I could have them setup wrong in the so2r box and N1MM. Attached is a pic of what my VSP manager shows them as. John

Dennis- Yes they are paired.? If I open up VSP manager it also shows them paired.? I was using these ports for so2r mini and they worked fine with it. John

John U didn’t say or show this so I’ll ask- have u checked device manager to verify comports are there? And are 21/23 and 22/24 paired? Dennis W1UE [email protected]> wrote:

I have bought a YCCC so2r+ controller.? I'm having trouble getting it to work with N1MM or DXLog.? I have made 2 sets of virtual com ports-(which I've used with my YCCC so2r mini), but I can't seem

If MAP1 and MAP2 are both mapped to radio 1 then the relays and audio would not switch and you would always hear radio 1. I don't know how it got that way. There have been a few reports over the

Thank you Dennis W1VE and Paul K1XM for your replies.? Resetting the EEPROM did the trick.? Before resetting, MAP 1 and MAP 2 were both showing "1."? After resetting, MAP2 was changed to "2," and

The microphone has a relay. The headphone switching is electronic so you won't hear any relays when it switches. The easiest thing to try is to reset the EEPROM in the SO2R Box. Run the SO2R Box

Check that an update didn’t remove your comports. Make sure you’ve only loaded one copy of program. Is Mic Relays box checked?

I've been using the so2r box for years, but suddenly this afternoon the mic and phones relays are not switching their lines.? The LED's look like it's behaving normally, but I don't hear any relays

OK. Good news. Yesterday I replaced the chip and the box is live&running! Again, thaks to all! best & 73 de Cezar, SP5Y

Yes. Just checked DigiKey and Mouser. It’s avalibale. I will try to ask nearby smartfon/laptop service to help me replace the chip. Will let you know how it goes. Paul, Dennis, Thanks for quick

Can you get a replacement? And can you solder it or do you know someone who can? Paul, K1XM

?Ok. Looks like MAX9722 is broken. There is -5V DC on OUTR (pin12). Cezar Wys?ane z iPhone'a Wiadomo?? napisana przez Paul Young <k1xm@...> w dniu 21.10.2023, o godz. 13:25: ? Hi