开云体育

Wondering if Denis or anybody still have microprocessor and or couple transients for SO2R box? de K0TF

K0TF Yes, I have pre-programmed microprocessors but no transients. You can easily obtain the transient suppressors from Mouser, Digikey, etc. Its Mouser part number 576-PGB102ST23. I received $10

... well as it turned out suppressors are NOT available (replaced with PGB1010603NR) , but its the least of the problems presently. MAXIM?MAX4574 chip only available in SOIC28 package (some NOS in

Using N1MMLogger+ (latest version) Could've sworn this was working in NAQP CW last weekend. Even reverted to previous version of N1MM logger and no dice. This is what I have in my F key: F9 V,{OTRSP

I have used this: F11 VL, {OTRSP VLATCHT} for YEARS in So2R...always works 100% but now it doesn't seem to work.? Have mashed that button thousands of times but now no worky-worky. All other

In the SO2R Box program, if you check Verbose SO2R at the bottom of the window, do the VLATCH commands show in the log window just above the Verbose boxes? Paul, K1XM

I am running 2 KB's and if I choose that function key on the *other* keyboard, I see something verbose the first time the button is pressed but have no way to interpret it. I think it's just telling

I've punched the VLATCH key on both keyboards a couple times and the verbose output is too quick to see how many lines are filling up but here's what I see Paul

The TX1 and TX2 commands change which radio will transmit. The RX1, RX2, and RXS select which radio or radios you will hear in the headphones. If you are not seeing a VLATCHT command in the log then

So, looking at my 2 screenshots below...are THOSE the commands I should be seeing or?

It depends on what you are doing? If you are changing which radio will transmit or which radio you will listen to then the logging program will send those commands. If the logging program sends the

Thank you Paul

aha! I figured it out There seems to be either a new setting or one I had never noticed before called Toggle/Stereo OTRSP Macro and it affects the way latch works. Whew ! Thought I was goin nuts

Paul, Something you said had me going to look for something like this very thing (I would've never known otherwise that such a thing existed) Thanks to you again.? Hope you are having fun.? Saw you

Hi All, I just put a new version of the software on the k1xm.org website. The new feature is support for TCP/IP connections. If your logging program supports OTRSP and WinKey over TCP you can

Hi Paul, 1.33 or 1.13? Mike -- 73, Mike, N1JEZ "A closed mouth gathers no feet"

Sorry about that - it is 1.13. Paul [email protected]> wrote:

Good Morning, I just received/built a "Run 4" box. It seems to work fine until I transmit local SSB audio at any power level over 2W. From 2W up, what appears to be RF feedback into the mic line

Hi Bob, What do you mean by a "Run 4 box"? I have a K4 but I haven't done any SO2R phone operating with it. The SO2R Box microphone switching is very simple - there is a relay which connects both

Bob I think by "Run 4", you mean a YCCC box from the fourth run. The only thing I see that you didn't comment on was that paint needs to be scraped at two spots- one is the where the ground lug is,