Paul,
?
on Nov 11 I ran into this situation:
?
I was setting up vm (dvr voice messages) on two K4Ds on Saturday. ?Using TRLinux and a YCCC SO2R Box + (this right probably only applies to two or three stations). ?VM were set up and I was testing what would stop a vm if I got a response on a radio. ?Normally an Alt-R would do this and it did fine. ?So I am remembering how if you hit the PTT (foot switch) with a K4D that will stop a vm. ?Well I tried that. ?What happened had me puzzled for 1/2 an hour. ?I lost audio on both radios. ?I was in Test Mode and when I hit M1 on either radio the radio would swing wildly in/out of transmit but I could not hear any audio (monitor was turned up) and still no rx audio. ?I tried rebooting the radios with the same thing happening. Finally after a while I found that the PTT was held low by my SO2R Box to both radios. ?Rebooting the SO2R Box fixed the problem.?
?
Now tonight Nov 14 I had this happen:
?
I was in a little bit of a hurry tonight getting things turned on and then ran into a big problem.? Whenever I would key a radio they would go into transmit and not come out.? I ran into this thing last week before the SSB Sprint and corrected it by rebooting the? SO2R box but this time it didn't work.? I guess I will have to reflash my SO2R box
?
?
W6FB replied:
I had this issue with my SO2R+ box a few weeks ago. I believe it was caused by killing power on the box instead of flipping the front panel power switch to off.
The solution was to bring up the SO2R Utility and reset the box, which resets the eeprom to default values. It worked until the next time I powered it off by?
killing the main +12V supply. I again reset the EEPROM with the utility and it has worked fine ever since.?
?
I learned my lesson, I now power it on and off with the front power switch, then when it is off, power off the main 12V supply.
?
73!
Jack,W6FB
So before I reflash is there anything I should look for using the utility so I can pinpoint what happened?? I have always just killed power and I have not used the switch on the SO2R Box.
?
Thanks,
?
Mike W9RE
|