Mugs,
? ?Thanks for purchasing YCAT!? ?
? ? This is a good place to make comments, seek support, feedback, etc.
? ? There was a time where YCAT did allow the mouse wheel to scroll the slider bars however with the FT-710 this became a problem with the way the FT-710 managed serial messages over CAT.? ?In order to provide support, the wheel mouse on the sliders was removed.
? ? The band buttons operate by sending a CAT band command.? ?I believe the frequency is the last frequency you operated in that band.
? ? There is another feature in Yaesu radios and that is the memory channel pairs P1L / P1U through P9L / P9U.? ?I use those to set my privileges for Advanced license.? What I especially like is that with my FT-891 the VFO will tune from the PxL to PxU limits (and vice versa) and rolls over.? ?The other radios (FT-710 / FT-dx10) just stop when they hit the limit and you have to tune in the other direction.? ?The FT-991a, I cannot recall if it rolls back or stops.
? ? There has been a request from a few users that the mouse wheel on the VFO readout changes in 1 KHz steps.? With the CAT commands the UP / DN commands are inconsistent between the radios.? ?This will be implemented in the next release.? ?We will look into incrementing/decrementing based on the digit the mouse is over.?
Best regards,
? ? Steve? - KC5NK
? ??
SteveO - KC5NK