开云体育

i bought a CS-60 (the one in the "ribbon controller fail" topic) and... the ribbon controller is working intermittently and has as an indentation - i'm not really a DIY repair kind of guy... and my

If you search the message history, you’ll see a few threads about replacing the ribbon (actually a coil - like a very thin Slinky). Kent Spong was selling these but I don’t know if he still has

I don't know, I have never had to replace a ribbon.... I hear some guys have done it... there may be a replacement spring or something that you have to re affix under the felt... some one should speak

ah... i was wrong... i put my iphone with the camera on inside the lid while closing it... the support is not directly on top of the ribbon but rather between the ribbon and keys... the ribbon must be

I dont believe that would be a place to put a support rod.... and if it were a support block,lets say to strengthen the lid for travel, I would suspect it is to touch between the ribbon and preset

here's a picture of my CS-60 lid... the "support" is that rectangular thing in the middle... it has a little piece of felt on it where it makes contact w/ the CS-60 front panel... specifically, for

there is no support on any cs80 lid I have ever seen.... ---- On Tue, 04 Feb 2014 15:34:55 -0800 <8bit9bot@...> wrote ---- this is a cross post from vintage synth - someone recommended i

this is a cross post from vintage synth - someone recommended i post the same question here so... here we go: my cs-60 is in pretty good condition but there's an indentation in the ribbon

I have checked the CS-60. It is in fantastic conditions. Esthetically, nothing is missing, no burn marks, scratches or major signs of time on the panels/keys. Functionally, EVERYTHING is perfectly

Hi all. Don't know why this just popped into my mind, but I checked the voice-card schematics and verified that the settings of the Feet switches only affect the oscillators and not the filters.

This actually went pretty well considering I'm only 5'4" and not exactly a body-builder. My wife did help a bit cranking the winch, but she's about 4'11" and 100lbs so she wasn't going to be lifting

Did someone achieve a complete VCF alignment? I'm asking this because while following the steps on page 11 of the CS80's adjustment procedure manual, I came across voltages that are different from

Thank you David for your welcome! Actually what's really funny is that i started the project of completely restoring my CS80 after finding that site, from which i shared that link from... and readin

Looks like a very nice PSU that David...!

PS I forgot to mention, It comes with the original case lid…

Hello all. I’m back after long time, due to the birth of my lady Fernanda (1,5 y ago) that set me in stand by for my keyboards… :-) To whom it may concern: I write because there is a friend who

I actually just won this auction this morning and picked up the power supply at lunch from the guy: http://www.ebay.com/itm/TEKTRONIX-PS280-DC-POWER-SUPPLY-/281243057114 Should be good for

Welcome to the group! As to the +8.5/-6.5 supplies, I’ve always found the problem to be a semi or hard short, usually one of the caps on the TSB boards. It’s possible it’s the op-amp or

Hi everybody, i'm new to this group, and it happens that i have the exact same issue with +8,5 and -6,5 for a few days now.I would follow Heath Finnie procedure by replacing IC722, and both 1000uf

Hi all. Wondering what modifications you might have seen / had done / thought of for CS80s and how useful they were. Some obvious ones are MIDI (Kenton kit give MIDI in but not out), unison,