开云体育

Thank you everyone for all the dialog and support to my queries and posts.? The Signalink is in hand and I clearly over thought this project.? The pin out of the signalink RJ-45 connector s obvious

I want to use the Signalink external sound card unit with my 920 for digital work.? I want to interface through the 5 pin din connector on the back of the radio.? The Signalink cable to pair the

Basic Issue; I am using the Yaesu FT-920 with a 9DB to USB cable to control my rig via Ham Radio Deluxe software.? All is well.? The various elements work well so I am comfortable that the cable I

Steve While I do not have the answer to your question, I would like to take it farther.? If I understand the 920 manual, the YF-116A/INRAD #710 filter is required for AM transmission.? So if you put

Morning Question may have been asked in the past but nothing came up with a search.? What were the production years of the FT-920?? My serial number is 9Fxx.? So I believe that to be April 1999.?

Hello group I am new here so please bear with me :) I have a FT-920 from a silent key who was actually a friend of mine (KV4DP) I took the rig to? sell for his wife (also a friend), but I ended up

Hello group I am new here so please bear with me ? I have a FT-920 from a silent key who was actually a friend of mine (KV4DP) I took the rig to? sell for his wife (also a friend), but I ended

Gene, The microphone was disconnected, and nothing changed when the MOX was activated, the ERROR came on. So I guess we are out of options? The radio is extremely clean, and looks almost like a new

I sure do appreciate you guys hijacking a thread I started and going back and forth.? A real stand-up move.

Gene, Interesting suggestion. I will give it a try tomorrow. Thank you for your suggestions, much appreciated. Kind regards, Christopher wrote:

Could possibly be a microphone problem try the mox with the microphone unplugged GENE MITCHELL. Kc0mqg TACTICAL.RADIO.GEAR@...> wrote:

Gene, I gave the tuner in/out a try and no change. Funny thing, in the CW mode I can operate the strait-key and get the side tone, but no transmit. Nothing changes, it acts like a code practice

Gene, Thank you four the suggestion, I have not given any attention to the tuner...this is the first suggestion thus far that included the tuner. I will be giving it a try, and will get back to

Could be a internal tuner issue there bad about it see if it will transmitt with the internal tuner off. But if you really are just done with it lmk how much you want for it I have several and could

Duane, My 920 will not transmit in any mode. A message ERROR shows up in the display. It receives just fine, but not xmit. I also did all of the reset(s) including changing the battery...nothing

Greetings, My 920 will not transmit in DATA-USB. It will xmit in all other data modes as well as USB phone. It acts like it wants to transmit as the receiver switches off and the 'TRANSMIT'

Unfortunately, I have not been able to get the ERROR message resolved. At this point, I am seeking suggestions for YAESU repair tech, and/or company that works on this particular radio. Thank you in

Check the memory battery if below 3v replace it. Very common issue with this radio GENE MITCHELL. Kc0mqg

The radio receives just fine, but when I try to transmit, an ERROR message shows up in the display, preventing the radio from transmitting. SSB, or MOX, the ERROR diagnostic message appears. I have

I performed all of the resets, to no avail; then a hard-reset, still getting the ERROR message...sigh! Not sure where to go from here? The instruction manual provides nothing that I can use in-order