You might want to associate the MESSAGE_TO event type; that will cause the sounds plugin to announce when a message addressed to your group arrives. Of course, that's only meaningful if you are using the sounds plugin. :-)
Andrew, KA2DDO
author of YAAC
________________________________________
From:
[email protected] <
[email protected]> on behalf of e m via groups.io <delivers1234@...>
Sent: Wednesday, February 19, 2025 10:34 PM
To:
[email protected]Subject: Re: [yaac-users] APRS Group messages
Do I need to or should have an event type for the message group?
Sincerely,
Eugene Mosqueda
Dominus Providebit
On Wed, Feb 19, 2025 at 4:32?PM Andrew P. via groups.io<> <andrewemt@...<mailto:
[email protected]>> wrote:
For YAAC to receive from a group, you have to indicate you are a member of the group by listing it on the Message Groups table on the expert-mode Configuration dialog's General tab, and then enabling the group. This allows to leave and rejoin the group without having to delete and re-add it on the table.
Hope this helps.
Andrew, KA2DDO
author of YAAC
________________________________________
From:
[email protected]<mailto:
[email protected]> <
[email protected]<mailto:
[email protected]>> on behalf of e m via groups.io<> <delivers1234@...<mailto:
[email protected]>>
Sent: Wednesday, February 19, 2025 7:10 PM
To:
[email protected]<mailto:
[email protected]>
Subject: [yaac-users] APRS Group messages
So I am able to send a group message by use the "To:" at the bottom via wide1,wide 2. Is YAAC capable a receiving a group message directly? or do I have to filter out from the messages.
Sincerely,
Eugene Mosqueda
Dominus Providebit
