开云体育

On 11/07/2024 04:54:22, Andrew P. <andrewemt@...> wrote:

Note the original poster has a G callsign (assigned to the United Kingdom) and a .uk email address. I don't think he's on our side of the pond. :-)

Anybody remember what the national APRS frequency is over there? Also note the the UK highly restricts automated station licenses, so there are very few digipeaters to forward more distant packets. Other users have commented on the scarcity of RF-hearable packets in certain parts of the United Kingdom, and the original poster didn't provide a more precise station location.?

Andrew, KA2DDO

author of YAAC

---

From: [email protected] <[email protected]> on behalf of GEO BADGER via groups.io <w3ab@...>
Sent: Wednesday, July 10, 2024 10:22:46 PM

No traffic on 144.390 MHz?

___

Sent from my two-way wrist watch

73 de W3AB/George

On Jul 9, 2024, at 16:58, Dave GM4NFI <djcleckie@...> wrote:

I am trying to get an old Paccom TNC 220 which I built from kit in the 1980's working as a KISS TNC.

I am running YAAC under Ubuntu 24.04 on a dedicated PC with on "old type" RS 232 port which appears as /dev/ttyS5

The TNC 220 is working fine as a Command mode TNC using PUTTY to enter commands all seems normal working as it did in the 1980's.

It has a KISS mode which I never previously needed so I am unsure how well it is implemented.

I want to use it as a KISS TNC with YAAC.

I set the radio ?and terminal BAUD both to 1200
Word Length to 8
KISS ON
Restart

TNC 220 lights flash in correct sequence to indicate it has entered KISS mode.

I use the the configuration wizard to configure YAAC - so far so good.

I add a Serial KISS TNC and configure it. /dev/ttyS5 what I was using with Putty when I use it as a command type TNC.

When I press the TEST Port button a blank command window opens.

If I deliberately enter an invalid/non-existant port e.g. /dev/ttyS6 (when it should be /dev/ttyS5) then I get the error "Unable to bring up Test-Port for Serial_TNC" but when I enter a correct port I get the blank command window .

From this I assume indicates YAAC has detected a KISS TNC?

The on-line help states the ... "Test Port" button provides a means of verifying that you have connected to the correct place; it opens a terminal window connected to the configured serial port so that you can manually test the TNC for the desired operation. To complete testing, close the terminal window."

My question is "What do I enter in this window to "Manually test the TNC?"

What should I see/do in this window to test that the TNC is operating correctly?

There is no packet traffic in my area for it to decode.

What commands should I enter in this command window to test the TNC?


73