开云体育

Hi Keith. WSJT-x and FT8 application in alternative firmware uses a frequency shift for transmitting. Generated audio have almost same base frequency (something like 1500 Hz). So - even 500 Hz of

Thanks a lot for information. Not sure, how much time it might took, I'm almost have no experienced with ASM and small with C/C++, but I'll try). сб, 7 дек. 2024 г., 20:03 Franco Venturi via

Georgy??? for FT8 it would be useful to have audio up to 3500 Hz?? when busy guys go up high to avoid QRM.? so 300 - 3500 or even 3600 would be great.? The factory firmware should have had that

Gergy, the MCU baseband firmware has enough space in RAM that it would be possible to append extra code/functions at the end to implement additional functionality. Since the STM32F4 is a ARM Cortex-M4

Hm.. I thought about more elegant solution - without reflash. But this might be an option too. Only one concern - current version can't flash new firmware. I'm afraid I can brick my radio while

If you could attaché a MFK option to call a Linux system function then it should be possible to reload a copy of the bbfw modifiyy and restart imho … DE M0RWV .

OEM firmware is using older linux kernel. As far as I understand - this network adapter is relatively old. Driver for it might be disabled in new kernel configuration or removed from the source code.

I guess I know where FM signal demodulated within decompiled BASE firmware. Perhaps, it might be multiplied by some value for increasing modulation level. I'll take a look. -- Georgy // R2RFE

Well, upper bound defined near lower in code, so, I guess, it's possible. I wonder, how to make this frequencies configurable during the runtime. Maybe someone have an experience with patching binary?

Thomas, since the Xiegu baseband firmware for the STM32 MCU is encrypted, I think you need their bootloader that has their decryption key to load it. What might work is to decrypt it first, and then

Still no Ethernet using USB adaptor. Belkin F5D5050? Ok on factory firmware

Big thank you to Georgy for this fantastic firmware. Audio is much more pleasant. Is there any possibility of extending the high frequencies to around 4Khz? Been looking at YouTube videos of eSSB and

*Situation:* Due to a partially torn CW key jack (ground pins) caused by the coupling of another transceiver, the protection circuit at the key input (implemented with a double TVS diode) and a MCU

Today I was curious to see how the X6100 internal battery voltage and charge vary over time when charging the battery from almost empty to full. Since those values are available on the second serial

Yes, you can. I'm using such adaptor for mine radio. -- Georgy // R2RFE

Can we still access Ethernet(with USB adaptor)? via Host port. Mine does not show activity.

I can’t tell from the photo how much smaller this mic is than the stock mic. Can someone post a photo (or at least the comparative dimensions)? 73, Randy K7RAN

The shutdown during low battery operation when turning on WiFi can be explained by the high pulse current consumption of the WiFi module during transmit - I perused some data sheet and found peak

It looks like firmware version is not 0.28 or some mess with browser, maybe another will do?

Well, if you did not restored previous params.db file after upgrade then you probably have default value of RF Gain which is 63. If so setting it to 100 may help.