开云体育

Hello! Personally, I think that making GHA responsible for building an image is a very good move! I can’t wait to give a try to new version. Thanks, 73 de Jarek SP9HGN W dniu ?r., 18.09.2024 o

Hi Georgyi ! Just coming home , saw Your mail .... ... what a big surprise! Just dowloaded , now start looking about and using it for the first time . Thank You very much in advance for all ...

Hi. First of all - thanks for all, who provided a feedback of previous versions. I switched to Github actions for build an whole image. Actual release available on the Releases page (

Hi. Callsign/QTH setting is on the 2nd APP page. 73. Georgy // R2RFE

Well, as rufus works Fine, usw. it. This Not a Problem of the x6100. I also have sometimes Problems with Balena Etcher also with other formwares, so what Von meinem iPhone gesendet Am 16.09.2024 um

I downloaded version 20.0, and used Balena Etcher to put the file on my SD card.? It tries to verify it, and then reports that it's corrupted.? I get the same error when I tried to install the

Hi. As the above title says, how do you change the Callsign on the FT8 firmware as the card I have is from the radios first owner with their callsign. Any help appreciated Trevor MM0KJJ

I confirm behaviour with strong signals on edge of spectrum - mirror appears on other side. Observed several times (mostly with wide spread digital signals). It didn't bother me since it`s not the

I used Balena Etcher on a MacBook to burn the image, and I had no problem.

Dear OM Greg, Thanks for the confirmation, and all the hard work. From one dev to another I know how much time this takes.. I wish I had more time to contribute! I burned months on the uSDX project

Thanks for all your work on this C. [email protected]> wrote:

I use the imager from the Raspberry Pi? folks.? It has worked every time for me.

Hi Scot. rc versions was created to check building full SD card image using GitHub actions. There are no significant changes. I'm going to publish next set of changes on 0.24.0 version. Hope will be

Hi Greg, Is there some changes between v0.23.0-rc.0 and ( https://github.com/gdyuldin/AetherX6100Buildroot/releases/tag/v0.23.0-rc.5 ) v0.23.0-rc.5 (

Works fine first time here with Balena Etcher, which I always use for burning ISO's. 73' Ron - ON2RON

Pay attention to DC plug dimensions. Compact 12V DC supplies may have 5.5/ *2.1* mm plug while Xiegu requires 5.5/ *2.5* mm.

You don’t need any particular model, just one that puts out the required power and voltage. I actually use a little power supply when it’s on my desk, so that I can run it continuously. It’s

Hi. I always knew, that strong stations close to + or - 50 kHz from central is shown on the both sides of the waterfall/spectrum. I performed a test with a CW tone generator. Generator freq is 21.200.

I have already answered this question many times. The plans included a range editor so that everyone could set it up as they wish. Perhaps Georgy will implement this in this firmware.

Georgy develops the firmware very quickly and I do not have time to track the changes ((: Therefore, I can not say anything Spectrum beta is not really speed, it is averaging. 73!