开云体育

George N2GWK, On another thought, use your X6100 with the int battery and see how long it last on the full charge.? I see about 2 hours of operation, 90% rcv.? If your X6100 runs this long I would

George N2GWK What voltage are you charging the int battery with.? My X6100 when the display shows the int battery to be 8.2V I consider it fully charged.? If the charging voltage you are using is

Sounds more like a firmware issue. Your description of how the battery actually behaves sounded normal although you didn’t mention how long it took to discharge (on receive only it should’ve been

The battery reading is notoriously incorrect. Nick Marsh Sent from an electronic device with a mind of its own.

I received my second x6100 about 2 weeks ago.? The first had a really sloppy VFO knob so they replaced it.??Charging cycles were performed and now I am getting an EMPTY Red battery icon with 8.2

Thanks - that makes sense. I looked at a very early version of your firmware. ?I'll take a look a the later version. 73 Howard K4LXY

??? Saludos. Diego. EA1CN

In the standard firmware, the filters are really made strangely. In fact, these are two consecutive BPFs. Those. only the part where the two filters intersect is passed. In an alternative firmware, I

Adjustment of the DSP filters adjusts width and shift at the same time. ?I'm used to having width and shift as separate controls. Can something help me understand what this adjustment is doing?

That may work. I thought of using the end cap screws or replacing them with longer screws to attach a mount but I think they’re too small and wouldn’t hold up under normal use. Probably the best

To everyone sending the Ebay links to the same item, that mount requires the radio to be sitting on a flat surface.? What I'm looking for is one that attaches to the radio, not one that sits on a

I believe so, I’ll remove the space and try again when I get home. Thanks for the tip. Nick Marsh WB4SQI Sent from an electronic device with a mind of its own.

Is there a "space" character in the name that your WiFi router broadcasts? Mine did and I had to remove it, otherwise the Xiegu firmware would ignore my network. IMO other special characters are also

If one were to install a ground lug like the ic705, where would be the simplest place to do so? ?Where would be the best place to do so? ?For anything that requires opening up the radio, is their a

Been there, done that dozens of times, no joy. Nick Marsh WB4SQI

You have to change the IP address to your network settings in the Wi-Fi setup on the radio and turn it on. There are instructions in YouTube videos.

You may need to make up a cable using the wiring details for the ACC port in the manual, with the tip and sleeve of a 3.5mm TRRS plug connected to the center and ground of an RCA plug for the other

https://www.ebay.com/itm/175803513388?hash=item28eeb4ba2c:g:KrQAAOSw7-VkVM6t

Here is one I

The reason nobody makes an attachable mount is that there’s no provision for attachment to the side of the X6100 like the ground lug screw on the IC-705. I think the only way to get there is