I received my second x6100 about 2 weeks ago.? The first had a really sloppy VFO knob so they replaced it.??Charging cycles were performed and now I am getting an EMPTY Red battery icon with 8.2 volts.? If I leave it on, the battery voltage decreases over time and then shuts down at about 7.2v level.? When I start the charge, the green light blinks forever, it never stops blinking and does not go to steady green.? Upon boot, it comes up normally and goes to the 8.2 v level with the empty red battery icon.??
I just went successfully though a firmware upgrade (Downloaded from the Xiegu site).? ?I guess it was at the highest level already because the System Info page on the rig did not change.??
As stated earlier, this is a replacement unit from Xiegu.? ?Do I have a battery issue?
Any help is appreciated.
73
George N2GWK
