开云体育

S-meter value is not streamed anywhere right now. I guess, it's possible to stream it to named pipe (FIFO). Let's discuss it on the github issues.

Hi Greg, woking perfectly for me on 1st generation x6100 hardware. FYI - Base 1.1.7 160Hz (patched) ?and APP 1.1.7. You may be able to answer if there is a way in command line to obtain the S-Meter

Do you copy all files and directories off of the DATA partition ( ie. including the .Trash-1000 directory and subdirs?) , and then put them all back again, or just the files in the DATA root? Thanks

FW 0.25.0 works WITHOUT issues. Problems are different X6100’s with different hardware faulth’s or install mistakes. Sorry for my comment , but I don’t like follow this discussion.... Sent:

Hi, For me, waterfall is now working. Spectrum and S meter are still frozen. Most of the menu buttons not working. Ft8 decoding also not working however this time the ft8 scope is displayed but only

Georgy, you made my day! You were right suspecting it was not V0.25.0... For some reason I cannot expalin (cache or whatever) the V0.25.0 was not written on the microSD by Pi Imager (I'm running

In 0.25.0 TX power and SWR indicators looks slightly different. Could you check, that It's 0.25.0. It shows a message with version on start. Adding app version to some place of application is on my

Here it is, on 20m Rgds, F5UJA

It's already done within 0.25.0. During TX it reads PWR and ALC values and calculates a correction to output audio level. Comparing 0.24.1 this approach might add +8.2 dB to output signal value (about

Hi Georgy, I was expecting a lot from this last version, after I reported a few weeks ago the power levels issue in FT8. Too bad, this has not changed since V0.24.1. Let me be more specific: Whatever

But NOT to forget : Same great thanks to Oleg too !!! Sent: Tuesday, October 1, 2024 8:16 PM To: [email protected] Subject: Re: [xiegu-x6100] R1CBU firmware 0.25.0 Hello Georgy... I am almost

Hello Georgy... I am almost speechless and very impressed about the new firmware version 0.25 !!! Just played with it and tested and measured for about 2 hours ... Everything seems to be working

Gary, I was able to replicate what you reported: " So the radio does run commands to address 70 but responds from address A4 " I used CatSync since I wrote it. Sending command with 70. Filtering

Joao, I have an unconventional x6100 config. I copied the 1.19 app x6100_ui_v100 into the 1.17 app on my radio to get the UI improvements of 1.19 (audio scope on/off, white text - not red) and the

Installed on mine with no issues whatsoever. Now testing, will give feedback if something needs to be fixed. Thank you so much for your work. It's appreciated. 73. Joao, CT2HME

Hi Gary, from what I tested, previous FWs did support 70. Lastest ones, mimicking the IC-705, seem to support A4. Here's an example: And the same command with A4: Also there are previous posts on the

I was (pleasantly) surprised that I got pretty good response from : tech-supp@... for an issue I had with no +8v regulated volts on the MIC connector of my x6100. This caused the radio to

Many thanks Joao! 73 Rob YS1RS

https://www.radioddity.com/pages/xiegu-download Look for components for the X6100 at the end of the page. 73. Joao, CT2HME

Yes, I did it to reduce image size and use whole free space for DATA.