开云体育

Hello, My CW decoder was working fine: decoding the station I was working immediately after I TX'd. Now, for some reason, it takes a lot of time to read what the other station is CWing. Any

Thank you, Rainer, I thought that was a possibility, but the names do not lead you to that conclusion and the manual is less than helpful in explaining. Take Care, Dan

Thanks you Ranier for the answer I did try with AGC A/S/F and it is actually worst, I have use the Radio twice. I notice yesterday on a Pota Activation, I had hell of a time trying to get the Call

AGC is off, try "AGC Auto". The switching transient during release of the PTT is the culprit. Greetings, Rainer DG1SMD

Dan, those are the audio ports of the internal soundcard (C-Media CM108). There is also a USB-to-UART Bridge (WCH CH342) and a USB hub. (USB Device port, the Allwinner R16 SoC is connected to the

X6100 on 10m with a Dummy load noise level is at S3 is I press PPT when I let go Noise level jump to S6 to S9 for a second them goes back to S3 is that normal? I have add a video is this normal I have

Under the radio settings I see entrees for LINE IN LV and LINE OUT LV.? Can someone tell me what these settings impact?? As far as I can tell there is no line level input connector.? Does the S/P

Thanks for you help I got it taking care... 73 KQ4WGS [email protected]> wrote: -- Nemury Valladares

It's issue of the ft8lib. I'll try to fix in one of the next release. -- Georgy // R2RFE

ALC shows only when ALC magnification turned on in settings. -- Georgy // R2RFE

Have you tried it with shorter suffixes?? I know adding /P works for me.

I decided to go ahead and post the corrected frequency response plots here. The ripple was completely pilot error. It turns out that the X6100 TX image rejection is not so great.? For my

I'm not sure if this is an issue, or maybe I am doing something wrong. I am trying to use the FT8 functionality (very impressive, thanks for this!) but while it works well with my regular callsign it

What do you mean you lost ALC?? On the X6100 the ALC should be 0 when operating normally.

This just happen I was just fine and I lost ALC, I have remove the SD card and test with Xeigu firmware with not issue any help will apriciate. 73 Nemury

I ordered (2) new lithium batteries for my X6100 from Amazon. My radio exhibited the same problem you're describing. The charge indicator in the radio shows the voltage of the internal batteries,

AliExpress does sell the batteries, there are 2, for the X6100.? But must take the rig apart to replace. Here is another

Ron, Oh my bad about the internal battery showing full. The radio is about 3 years old and stayed in the box mainly. US

I ask how do you know the internal battery is charged.? With ext source the display shows that source's voltage, not internal battery.? Only way to see internal battery is charged is with rig on and

Ron, I forgot to mention that. It turns off when external is removed. US