开云体育

I'm using WinKeyer along with FLDigi, and there seems like a long lag, (at least in the context of contesting), between when I execute the macro and when the message actually starts transmitting.

I am still having trouble sending CW with fldigi. It turns out that dxlab winwarbler works just fine for CW and sometimes fldigi works right after using winwarbler. Powering down the transceiver and

I have seen this signal as well and haven't been able to identify it. All I can gather is that it's 8 distinct tones in 500Hz bandwidth with a very low symbol rate. Other than that, I have been

It appears to be a harmonic of a Very Overdriven FT8 (12 seconds) signal

Andrew, thanks for your input. I am still going to give the D-U and D-L approach a try. Nothing to lose. Bill KD9TWA [email protected]> wrote:

I have heard that signal before. I am guessing it's one of the wsjtx modes/sub modes with a 15 sec sequence (12 sec transmit), but haven't heard it on long enough to cycle through them. It is not FT8

Jeff: if it returns, and if you have not already tried this, you may wish to switch your receiver from USB to LSB to see if that makes any difference.I am wondering if that signal originates from

Totally agree about the tones and the timing. I'm definitely not an expert, but that signal looks and sounds nothing like FT8. If it's a harmonic (as has been suggested), wouldn't it at least have to

That looks like FT8.? You can see the 8 tones and timing also matches FT8. But the 500Hz width is really strange.... Mike W9MDB

UPDATE: Disappeared around 1625 UTC (1125 Texas time)

Hi all, I'm seeing and hearing this on 21070 dial (21071.5 wf) on 24 August 2024 at 1540 UTC (1040 AM Texas time). I'm cycling through the various modes but nothing is decoding. It transmits on :00

Sorry I missed that you were mainly operating CW, decoding in fldigi. So I have done lots of CW decoding in SSB in the -D mode on G-90, but have not done transmission so I cannot be sure the signal

I'm trying to get prepared for the Hawaii QSP party tonight, but this question applies to any contest. I believe I have FLDigi and N3FJP hooked up correctly and talking to each other. CAT works and CW

Thanks for the info Andrew. I was hesitant to use the dash U or dash L because many folks seem adamant about using the CW mode. Maybe since I'm using WinKeyer for the code generation, it isn't as big

The G-90 needs to be in USB-D or LSB-D, with the input source set to Line. FLRIG does not know about these settings so will be in USB or LSB after it performs init, manually change it after. My

I'm trying to use FLDigi as an encoder/decoder with the Xiegu G90. I think I'm close. The problem is I can't get the FLDigi waterfall to show activity. Adjusting the *two selections at the bottom of

I have uploaded a copy of Flamp2.2.12 Setup to the Files area.

I have uploaded a copy of Flamp 2.2.12 Setup.exe to the Files area. N2ADD

Yes that's right version 1.4.7 works fine with VSPE. My issue was with the later versions. Guess as youbI will stay with 1.4.7. -- DE Bruce VK2RT

No problem here with Flrig 1.4.7 and VSPe with icom radio. What radio are you trying to connect with the split ports. -Arvind [email protected]> wrote: