开云体育

Good morn (here On the banks of the Piscataqua, anyway ;-) Thanks for the reply. Tobias earlier reported in a different thread on a related subject: "Your wav file signal looks exactly as expected: a

Hello George, I wasn't aware this 'reset' might happen once the values were manually set. To prevent any direct FLdigi induced modifications, you can, of course, edit the fldigi.prefs file and then

What “mode” are you using when you see this? I think all Thor modes do send a string of characters ?to “clear the buffer” I hear it go fom low to high pitch tones like a trombone. Go to Psk31

Hello Tobias, Well the issue has returned with the wide gray area where the TX text was.? What is strange is that when I close the program the "int_tile_y_ratio:" is reset to 835, it's original

Hi George, Thanks a lot for sharing your experience. Since we kind of tweaked the 'standard' user interface behavior, it may well be that the full height is not updated until you restart FLdigi. So

I just tried it again after closing the program and things now work as they should.? I will keep an eye on it. Regards, George

Greetings, I like to decode the Europe feed of news items as described at RTTY.com. Please see the attached picture. The gentleman that is one of the go-to people on this replied to by question as to

Sorry, I forgot to post the image.? Look at the one with blue text.

Hello Tobias and Rich, Thank you both for your replies.? Rich, I did lower the TX area as much as possible, but it still had a few lines of height.? Tobias, I had to user 1100 as the magic number

Best wishes to you in Bavaria! 73 Rich NE1EE The Dusty Key On the banks of the Piscataqua

Hi Rich, Thanks for your detailed reply and the wav file. Your wav file signal looks exactly as expected: a leading short (1 second) center frequency tune tone, followed by the (non-)message

Thanks for the reply...I am using COM port to toggle, configured in fldigi Hardware PTT. ~R~

Tobias Thanks for a) recommending the audio file. I have not used it in the past, and forgot about it. b) the config menu. It turns out that I already have ending RSID OFF. For personal reasons, I

is this with a vhf/uhf HT or hf HT?? are you using vox to key? it sounds like the ptt is dropping as expected, increase the vox delay. does any results ( answers) come back to your sending Dave Garber

Hi Rich, Maybe it's easiest to 'Menu - File - Audio - TX generate' a short wav file with the respective audio produced by FLdigi. Before using the audio file, make sure to repeat the same Menu command

I found most of the delay. I automatically turn on RXID and TXID in my macros to select the modem protocol. So fldigi must send the ID at the start of the transmission. Not sure why it then sends

If TXID (and RXID, I suppose, though it shouldn't have an effect) is turned off, and I toggle T/R, I see fldigi TX something at the beginning and the end. I don't have anything in the TX pane to send.

I am using a digirig 1.9. Windows 10 fldigi 4.2.06 If I select Tune, when I toggle it off, PTT drops within 1 s. If I toggle T/R with no data to send (just for testing), the delay is there after I

Hi George, If you are comfortable editing an FLdigi config file, you can try this sequence (back up the original file before, in case there's an issue): 1. Close FLdigi. 2. Open 'fldigi.prefs' in your

I don't have mine handy, but ISTR that all you do is drag the divider... 73 Rich NE1EE The Dusty Key On the banks of the Piscataqua