Re: Signalink audio level changes with frequency
|
U-10 ( ) Function: Selection of Enhanced Tuning Scale choices Available Values: / ! / " / #? Default: ! The Enhanced Tuning Scale, located immediately above the VFO-A frequency display, may be used to provide a visual indication of several transceiver operating characteristics: When the Clarifier is active, a small dot below the horizontal Enhanced Tuning Scale shows the relative offset of the Clarifier from the displayed VFO-A frequency. Note that this small dot will be observed on Receive when the RX Clarifier is on, but only on transmit when the TX Clarifier is on. ! When the DSP is On, this scale provides a relative indication of the bandwidth currently set via the High-Cut and Low-Cut knobs.
On Wednesday, November 20, 2024 at 10:54:26 PM CST, Tom Schmidt via groups.io <tschmidt6060@...> wrote:
Hi there. When I operate digital modes in FLDigi using my Signalink USB, why does the audio level change when frequency is changed? I'll operate, say, PSK31 on my Yaesu FT-920 at the lower end of the passband at a set audio level. Then, when I change to the higher end of the passband, my audio level will be too high, forcing me to lower it so as not to splatter. When I change back to the lower end of the passband and transmit, my audio level is in the mud, forcing me to turn the audio up. Why is that?
?
Tom, N8EUI
|
