开云体育

Hi Richard...? you know... ya think that just might be the way to go???Would you need to know the diameter of the middle shaft? Because I heard someplace in all my calls today something about the

Ah, awesome ok. I'll get some pic tomorrow. Thank yee!

Before welding the crack needs to be deep "V'ed" to get down to clean metal. Cast iron has a coating that doesn't weld very well. After grinding the case should be heated to 500+ degrees in an oven or

Marc, Can you post a few pictures of where it is cracked? Lock-n-stitch makes some great cast iron repair options. And none of the risks that come with welding. Curt Sent from beautiful Bessemer

I don’t know where you are located. I have a case you could have. I’m in Wisconsin. To properly weld cast it must be heated first, welded with nickel rod and allowed to cool slowly. We used to put

And afterward to cool slowly. If it is not in a bad place, it could be brazed easier than welded, but you would have to get the crack area red hot for the brass to bond. Barrett? Pruit

Bob and John –Thank you too! ? Sent: Wednesday, March 17, 2021 5:01 PM To: [email protected]; AWORKOFMARC <marcwhittemore@...> Subject: Re: [WillysTech] Know of a place I

Oven, not one for consumable food. Get it hot enough to expand W/heat until.it normalizes.Try V TRY HERM THE OVERDRIVE GUY! Sent from my T-Mobile 4G LTE Device Get Outlook for

You should heat it with a torch before welding to help stabilize the metal. John'56 Pickup TKER TOYGraham, Wash. On Wed, Mar 17, 2021 at 4:03 PM, AWORKOFMARC<marcwhittemore@...> wrote: You are

You are the best!!!THANK YOU!:)

It is cast iron, not the easiest to weld, but can be. Use ss rod. Might depend on where it is cracked. It must be a Dana 18 in a 57. Pruit

Try willys truck warehouse in rodeo, ca.

Hey Gents.... Found out my 57 Wagon transfer case is cracked. Booo. Wondering if it can be repair welded (that is, if it's not made of pot metal) or if there's a recommended salvage yard I might

Here's yet another detail that needs to be finished on our wagon.? I've had this "custom" hitch for years - it needed to be thin enough to fit between the oversized gas tank and the valance.? The

If you look through all their YouTube posts, they have had their engine out twice so far. So they seem to be doing a lot of wandering around. Near as I can tell, they are in center Mexico now. They

Are these adventurers planning to do the trip now (February, 2021)?? I hope not because they will not receive a warm welcome in BC.? We are at about the worst point in the 2nd wave of the Corona

I thinkn their biggest obstacle before reaching the US is the fact that there is no road that connects Columbia and Panama through the area known as The Darien

<div>Unless they speak english or a tiny bit of german i don't know how much help i can be.</div><div><br></div>Sent from my Verizon ASUS tablet

Gang, I stumbled across a couple from Argentina who are driving to Alaska in a late 50s Willys wagon... L6-226 engine, 2wd It crosed my mind that when they cross through the US, we could be a support

LOLOLOLOLOLOLOLOL OMG!!! Sent: Monday, February 08, 2021 1:42 PM To: WillysTech Subject: [WillysTech] Jeep car wash Why you don't want to know what they do when you take your car in for