I wish I'd measured mine while it was in. I stuck it in temporarily to get
the motor mount locations marked, took some pictures but forgot to take out
the tape measure.
_________________________________
Chuck Pedretti MCSD, MCSE
Consultant
Magenic Technologies
mailto:chuckp@...
_________________________________
(46 CJ)
_________________________________
toggle quoted message
Show quoted text
-----Original Message-----
From: Bill Lagler [mailto:wbl@...]
Sent: Tuesday, June 22, 1999 6:51 AM
To: WillysTech@...
Subject: Re: [WT] Buick 225/231 front axle clearance
From: Bill Lagler <wbl@...>
Chuck Pedretti wrote:
From: Chuck Pedretti <ChuckP@...>
A question for those of you with factory and repower Buick V6's in
your
CJ's. How much clearance do you have between the crank pulley and
axle
pumpkin. A picture of mine is at
http:\\staff.magenic.com\chuckp\engine.htm
at the bottom (note the custom oak tierod :) I am running
a 2.5" lift
and
was suprised at how close to the axle the pully is. It probabally
won't hit
but I though I'd check to see what is normal.
Got my 2nd hand AA engine mounts and they look great as long as the
part
which mounts to the frame is inverted.
I'll try to get some measurements from both of mine tonight.
Bill
47cj2a
--------------------------------------------------------------
----------
_/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/
WillysTech
NEW! Parts Buy/Sell/Swap Board
Vehicle FAQ Sheets
Parts Resource List
_/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/ _/
