On Thu, Jan 13, 2022 at 11:24 PM Kurt Konrath via <kurt.konrath=[email protected]> wrote:
You need to separate each district.?
Plastic joiners work but if rail is down you can use thin fiber disk in Dremel tool to cut a thin gap.?
This gap can be filled with styrene glued in place with CA and filed to profile of rail. ?
It¡¯s but one way to gap rails.?
You don¡¯t have to pull track up to isolate rail districts.?
Kurt?
On Jan 13, 2022, at 8:28 PM, Steven Tobias <srtobias29@...> wrote:
Hello
I am using the Digitrax PM 42 to segment 4 power sub-districts.?
My track is already down and soldered. I did not use plastic insulating rail joiners to separate the districts. Is this required? Do I have to pull up track?
