A jewelers saw, commonly used for cutting rail, will also do in a
pinch, just be sure to go gently, or when the saw snags, as it
will, you'll rip the rail out of the plastic ties.? If you don't
own a Dremel, it's an expensive solution compared to a small saw.
Be sure to cut both rails to isolate districts.? You can't get
away with just one cut, you need both cut.? And for reversing
sections, the same thing applies.
Blair
toggle quoted message
Show quoted text
Hello
I am using the Digitrax PM 42 to segment 4 power
sub-districts.?
My track is already down and soldered. I did not use plastic
insulating rail joiners to separate the districts. Is this
required? Do I have to pull up track?
Thanks,
Steven Tobias
