开云体育

LO =local oscillator

For TinySA Ultra+ CONFIG: * *LO OUTPUT* enables the output of the first LO through the high connector Can you explain what is this, because I think about LO as TinySA lower output port and this does

So, I see LEVEL CAL is under CONFIG. Does this mean CONFIG->MORE->CLEAR CONFIG, Unit must be recalibrated?

I can say that if you buy from R&L Electronics, you can absolutely be guaranteed of getting a legitimate unit. I have purchased a TinySA, a TinySA Ultra and a NanoVNA H4 from them. All are excellent.

Hi Clyde It was from one of the listed companies "Zeenko". Dave [email protected]> wrote:

Thanks Erik. I didn't expect you to answer but it is nice to see the designer active ! I did buy from Zeenko so that much is ok. The unit is the base Ultra model. It accepted the update code from the

Everything you set in the CONFIG menu is in the Config. Everything else is in Settings which can be stored and recalled from preset -- Designer of the tinySA For more info go to

Hello. Please clarify, what parameters are stored in: - Settings - Config - Profile Or, what is difference between them. Unit: TinySA Ultra+

Where did you purchase it? [email protected]> wrote:

The only way to know for sure is to buy from an approved seller, see wiki -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Hi I just purchased my TinySA Ultra after running across it but after reading a bit I am now paranoid as to its authenticity. I saw and understand the designer posting that he didn't want to give away

I second this. Presets do store names, which is a workaround meanwhile.

P.S. Another issue with same feature: when disabling band element, name in menu replaced with frequencies, and name on screen became start frequency.

Hello. I've opened issue#136 on https://github.com/erikkaashoek/tinySA/issues Not sure if github is in use. Here is a copy: I created multiband config for all 8 slots and named each slot. after saving

Are you running the latest FW? The only thing left is to load a very old FW (maybe the oldest Ultra FW you can find) and then load the latest FW. THis will force a reset of any preset and config data

Level indicators did not turn red. I have tried this maneuver many times over the last couple of days and the behavior is as stated above in every case

Yes -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Thanks! So, if i am geting around -35.6dBm from CAL output - i should be good to go?

It is impossible to complete the detailed calibration process without an functional LNA as it is used in various places However you can do a simple level calibration that should be sufficient for the

Leveling process enables it in some steps. To, well, level it. 30 апреля 2025 г. 10:07:26 GMT+08:00, "Hugen via groups.io" <hugen@...> пишет: