开云体育

Hi, ""So you don't want reports of new clones of your hardware?? Am I getting that right?"" yup ....? there's pretty much nothing that can e done about the clone sites anyway ""If so, that's

bad guys on how to avoid detection. That's not rocket science. Please apply brain to issue and conform to the wishes of the developers who have done such a spectacular job. ++++++++++++++ --

Erik, Thanks for replying, wasn't expecting the designer to reply. So you don't want reports of new clones of your hardware?? Am I getting that right? If so, that's fine and will leave it at

Hi guys, I got the? TinySA Ultra+ ZS406 today from Eleshop. I updated the firmware to tinySA4_v1.4-198-g996a67b.bin (Picture 1). Before that, I had a Firmware from January 2025. I did the Self test

No. Please do not share any information on clones here. -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I don't like FAKE hardware clones.? The original developers/artists/etc deserve that (as one myself). Is this the right place to report a new clone I found? Thanks.

Erik, Maybe you want to lower the tolerance for this self test item. Roger

Hugen, your comment is interesting for me, because the test fail #8 did not occur in every test run. Sometimes there are 4 or 5 good runs , but the next fails. Sometimes there a 3 or 4 bad runs that

Sorry, it really isn't a clone. This is due to a deviation in the IF filter, and although we have rechecked it several times during the production process, there are still some with smaller deviations

You did not buy from an authorized vendor so you might have received a clone.

This does not look good and can not be repaired by different FW or other user action -- Designer of the tinySA For more info go to https://tinysa.org/wiki

My TinySa Ultra+, just bought on Amazon from Pinsaitec, fails on selftest #8. I have implemented newest firmware, have done several calibration runs! No efford! What can I do, before returning the

If doing a restart while pushing the jog button to the side does not help its a HW fault -- Designer of the tinySA For more info go to https://tinysa.org/wiki

My TinySA ultra device is giving me a "SI4468 Configure Fail" error and is not coming up. Any advice on how to recover ? Thanks Sridhar

New FW release Version V1.4198 All Ultra versions Changes: - Possible reduction of spurs around? 4.278 GHz visible on some ZS-407 HW -- Designer of the tinySA For more info go to

I have a similar prob although not quite as bad, the rear of my 407 is the same as Andrew's except the serial # as expected. Mine also appears to be a little later as the serial # is greater. I've

Let me make a joke:?The next person that complains about spurs in Ultra mode with spur reduction forced off gets banned from this group :-) -- Designer of the tinySA For more info go to

Correction on my previous mail frequency is 4.2766 GHz (typo). On the plot with spur removal off Markers 4 & 7 appear to be ambient ingress not spurs. -----------------------------------------From:

Erik, I too have the 4.766GHz spur as described by Andrew. as purchased from R&L a couple months ago. The attached plot #1 is with a terminated input, Spur Removal ON. No change with the

OK, let me try to improve the situation at 4.3 GHz Just to be sure, there is nothing wrong with the HW. -- Designer of the tinySA For more info go to https://tinysa.org/wiki