开云体育

Hi, If you mean the short horizontal bar, that looks like noise just increased briefly on entire band. It's difficult to say what that is. But if you're talking about the vertical lines visible in

Hi, I am am since a year a radio amateur, and i am learing moren and more but also finding interference issues here and i want to find them and if possible eliminate them. For this i ordered the

The? HW is unable to detect multiple touch and the graphics can not support zooming? in a code efficient way -- Designer of the tinySA For more info go to https://tinysa.org/wiki

PS, That was Digikey not digital. Darn word correction. I hate a phone that tries to think ahead for you! Anyway Clyde KC7BJE

It is available in several places on the net. Just google for BGA2817 to see if threr is any place near you. Mouser or digital for two. Clyde KC7BJE

Can you suggest me supplier for BGA2817?.

My Android smart phone has?that feature. You can zoom/enlarge the screen image by spreading two fingers on the screen. Is this possible with TinySA in the future?

I know mine goes at least to 12 GHz in Ultra mode because I've used it to peak up 12 GHz sources. Zack W9SZ [email protected]> wrote:

Here are the specifications for the Ultra: *Spectrum Analyzer spec:* - Input frequency range from 100kHz to 800MHz (900 MHz for Ultra+) in normal mode and up to 6GHz ( 7.3GHz for ZS407 ) with

Erik, Isidro, Returning to old thread. In my recent post #19273 I asked the same question, and this discussion (starting at #8369) is basically identical, so as I read the discussion here, I remain

I don't want to force a standard 3.5mm 3 conductor jack all the way into my TinySA Ultra and take a change of breaking it. Has anyone tried using a two conductor jack and, if so, did it make the

The frequency correction should be in Part Per Billion of the generator output frequency. As you can not correct below +/- 58 Hz error it is best to measure 1 GHz output and only correct 1 GHz. All

Indeed, in the CONFIG/EXPERT CONFIG/FREQ CORR menu you can make a correction of the output frequency when Tinysa Ultra is configured in generator mode. The value to be entered must be negative if you

Thank you very much for your reply. I looked in the PPB menu but I wasn't sure how to enter the calibration value either. Positive or negative. I will try which one works. Congratulations on the great

Erik's response to this question.... /g/tinysa/message/19281

THX Kurt, Look forward to it. Also I join a lot of folks that appreciate your efforts to improve the technology not only on the Tiny SA but on the NanoVNAs as well. Regards.....Ted

Its a good news!! Thanks. [email protected]> escribió:

There are two things determining the frequency accuracy 1: The global CONFIG/EXPERT CONFIG/FREQ CORR. This can be set to correct output versus the internal reference. In your case you have a 350 Hz

Yes the tinySA can be calibrated for improved frequency accuracy.? Read the wiki for details.? Look under Expert Config .for FREQ

Hi Ted Yes, indeed I will create an update. And it has long been on the to do list, but I have been very busy with the ZS-406 and ZS-407 correction tables. I am still studying accuracy leveloffset