开云体育

My Android smart phone has?that feature. You can zoom/enlarge the screen image by spreading two fingers on the screen. Is this possible with TinySA in the future?

I know mine goes at least to 12 GHz in Ultra mode because I've used it to peak up 12 GHz sources. Zack W9SZ [email protected]> wrote:

Here are the specifications for the Ultra: *Spectrum Analyzer spec:* - Input frequency range from 100kHz to 800MHz (900 MHz for Ultra+) in normal mode and up to 6GHz ( 7.3GHz for ZS407 ) with

Erik, Isidro, Returning to old thread. In my recent post #19273 I asked the same question, and this discussion (starting at #8369) is basically identical, so as I read the discussion here, I remain

I don't want to force a standard 3.5mm 3 conductor jack all the way into my TinySA Ultra and take a change of breaking it. Has anyone tried using a two conductor jack and, if so, did it make the

The frequency correction should be in Part Per Billion of the generator output frequency. As you can not correct below +/- 58 Hz error it is best to measure 1 GHz output and only correct 1 GHz. All

Indeed, in the CONFIG/EXPERT CONFIG/FREQ CORR menu you can make a correction of the output frequency when Tinysa Ultra is configured in generator mode. The value to be entered must be negative if you

Thank you very much for your reply. I looked in the PPB menu but I wasn't sure how to enter the calibration value either. Positive or negative. I will try which one works. Congratulations on the great

Erik's response to this question.... /g/tinysa/message/19281

THX Kurt, Look forward to it. Also I join a lot of folks that appreciate your efforts to improve the technology not only on the Tiny SA but on the NanoVNAs as well. Regards.....Ted

Its a good news!! Thanks. [email protected]> escribió:

There are two things determining the frequency accuracy 1: The global CONFIG/EXPERT CONFIG/FREQ CORR. This can be set to correct output versus the internal reference. In your case you have a 350 Hz

Yes the tinySA can be calibrated for improved frequency accuracy.? Read the wiki for details.? Look under Expert Config .for FREQ

Hi Ted Yes, indeed I will create an update. And it has long been on the to do list, but I have been very busy with the ZS-406 and ZS-407 correction tables. I am still studying accuracy leveloffset

To: Kurt Poulsen, Hi Kurt, a quick question: The very excellent Ultra Menu Tree document you published back on Aug 10, 2024, then current to ver 1.4.176, while mostly still up to date, lags behind

Hello. First of all, congratulations on a great job with the Tinysa ultra. I have the ZS405 version with firmware 1.4-192 and I would like to discuss a topic with you. The frequency accuracy in RF

Hello. First of all, congratulations on a great job with the Tinysa ultra. I have the ZS405 version with firmware 1.4-192 and I would like to discuss a topic with you. The frequency accuracy in RF

https://web.facebook.com/photo/?fbid=1180587507083729&set=g.2715786312037088 @ Mijo

Check out the post from this member:? /g/tinysa/message/14770? or search the archives for "10ghz" or "YIG". Herb

I'm working on resurrecting a Wiltron 6600 series sweeper (10 MHz - 18 GHz) with multiple problems (I think it was a combination of salvage parts). My old systron donner 762-2A spectrum analzyer (and