On 10/15/05, Leon Heller <leon.heller@...> wrote:
----- Original Message -----
Check the coil connections Those are the most likely cause of the problem if
all the solder joints are OK.
If you have a 40m Tx you could use that for testing, or make a simple test
oscillator if you have a suitable crystal.
I soldered all the connections again and my gnuradio software seem to
pickup something from the little board. There is heavu QRM here in
VU-land now. I connected a long wire as the antenna. Have to check
again tomorrow morning. Thanks a lot folks. Will have to refine the
software. It's not release-worthy yet. Will keep the list updated.
I need to build a test oscillator or get an XG1 next.
--
73 - Ramakrishnan, VU3RDD
Ramakrishnan Muthukrishnan