--- In softrock40@..., Robert McGwier <rwmcgwier@c...>
wrote:
This is not what we do on the Softrock40. The 11 kHz IF is used in
the
SDR-1000 in order to do exactly what Frank says and that is avoid
1/F,
DC, junk, noise, etc. at 0. We are attempting to maximize the
performance.
Hello Bob,
Could you resume in a few sentences the difference between the
SoftRock-40 and the SDR-1000 in this regard?
I could go back to the articles on the SDR-1000 and try to figure it
out, but I think that you can give a better answer.
The softRock-40 has a fixed oscillator and can software-tune +/- 24
kHz around that frequency which means that near the oscillator
frequency we get "junk". With the SDR-1000 what happens when we tune
a particular frequency?
Jean-Claude Abauzit, PJ2BVU
