开云体育

hy guys, how much can i ask for an Zetron Maz 48 these days on the used market! i need advise , thanks gervais ve2ckn

I am familiar with that controller. I have two of those. Was trying to find something used that would be quite as much money but decided to pull the trigger on a new one from Ken. So guess I'm not

Hi Chad, Regarding your request for a repeater controller with link ports, the Arcom RC210 is user-friendly and meets your requirements. There might be one for sale within the group. For future

Hi, does anyone have a good working repeater controller that would have at least one if not, two link ports as well as a repeater port? Chad Nelson WI9HF/WRPL979 Janesville Wisconsin 608-754-8671 Send

Sold

If it's still available, I'll take it. Chad Nelson WI9HF/WRPL979 Janesville Wisconsin 608-754-8671 Send from my spectrum iPhone 16.

Less than 1 year old Arcom RC210 Repeater Controller for sale. Rev 4.1 board. Has three TX/RX ports and logic input and output. Purchased pre-assembled from Arcom with rack mount case. Has DB9 type

Before you get too far into this, you may want to look at the FCC Regulations related to identification, and more importantly, remote control. Mick - W7CAT

Gang, I have a Commander Technologies 620-N2, black version, with 3 degrees of electrical down tilt and anther 3 degrees of mechanical down tilt top mounted on a tower on Mt. Wilson.? It's been up

Date: Mon, 19 May 2025 12:44:52 -03 Does anyone have the manual for the JSR RM3500 automatic modulation meter? Thank you. Marcelo F. Ruiz

I have quite a few amps that were decommissioned recently and need a new home. These have a built in power supply so they are kind of a cool self contained unit. All have been tested and work well.

It always restarts immediately after it unkeys. It’s fine when it is key-down. Just after it unkeys. This has just started happening within the last few weeks. I may try hooking it up to the Astron

Agreed. Had the same issue before. Dab a little dielectric grease on all pins to help keep clean and prevent oxidation. Benjamin, KB9LFZ [email protected]> wrote:

I am looking for several RLN5933 in-dash brackets for the XPR4000 series radios to finish off a project. This is a bracket that fits into a single DIN dash opening in a standard vehicle. Apparently

Prices have gone up, but if you're not logged into Tessco, you're going to see rack rate - [image: image.png] [email protected]> wrote:

And...quality has gone down... [email protected]> wrote:

The Commander Technologies 220-N was mentioned.? Even though it shows a wide bandwidth, if you go that route be sure you order it for your specific transmit operating frequency. Burt, K6OQK

I would definitely try external DC power. That will rule out the internal switching supply (but not the board that sits on top of it, I believe it's called the filter board). Does the repeater power

Hello all, Our club has a Vertex VXR-7000 VHF repeater that has recently developed a problem. Whenever it finishes transmitting, it always power cycles. This happens both in remote mode with two

I realize we needed the program the pins, we just needed to pin out diagram, which was found. Thanks. Chad Nelson WI9HF/WRPL979 Janesville Wisconsin 608-754-8671 Send from my spectrum iPhone 16.