开云体育

If you need help, I'll email you my cell and can walk you thru it with my RSS open [email protected]> wrote:

You don't change it in the service windows. In your last picture where it shows messages, click on edit and then if I recall station... That's where you change frequency, etc. [email protected]>

I have a helper rf voltmeter that I've picked up at a ham swapmeet for $5.00..still works but needs calibration.

No option to change channel info when you read the system and now I got a red light

The only info I've ever found on that supply is here: https://www.repeater-builder.com/test-equipment/helper/pdfs/final-catalog.pdf It's on page 5 or 6... I used to use one back in the mid to late

I ran across this issue.... 1.? Read the original codeplug and save it to another name. 2.? Open the codeplug you just saved.? It should have "personality" at top of screen.... make your changes

I just bought a BluMax cable and plugged in to my WinXP/32 laptop.? I can read/write an MTR-2000 just fine.? A friend has another MTR-2000 with BluMax cable with Win7/32 and he cannot read or

As others have said MTR2000's CPS only runs on a Windows 32bit OS. I have a Windows 10 Pro 32bit installation that works fine using a USB to Serial adapter, I have an old Windows XP Pro computer with

Most likely you have the unit setup as a reciever... hafta change it into repeater mode..cant remember where the setting was for this

I emailed blue max for a return but have better and worse news at the same time. made my own cable with the db9 cable. Worked like a charm. issue arises…. can read the station and see all the stuff

You don't mention that you contacted Bluemax49.? I've purchased several cables from him and had no problem.? He was good about answering questions. Joe, K1ike

I have a 2660D and would love to connect an LCD monitor to my unit. Sent: Wednesday, March 19, 2025 9:23 AM To: [email protected] Subject: Re: [repeater-builder] Motorola R2600 VGA

Likely an issue with drivers and/or OS versions as described above? I have NEVER had a Bluemax49er cable failure to work as described. They are my FIRST choice for cables with any of my projects.

In ham radio - it's possible to have the transmitter appear on either side of the receiver.? With duplexers that provide symmetrical performance - duplexer ports marked "Transmit" and "Receive" or

Ok so this is the setup. IBM Lenovo laptop 697 MHz with 0.97 megs of ram 1 gig basically. running windows xp 32 bit no true com port but two usb available. Installed all the different persons of the

I programmed a MTR-2000 with my laptop running 32 bit Windows 7 and a USB --> RS-232 adapter. Mick - W7CAT

The band pass is tuned by the shaft. The capacitor tunes the notch only.. I use a spectrum analyzer and service monitor to tune my Wacoms, DBs, TXRX, etc..Kit Parsons at Wacom suggested a signal

Gentlemen, What is the "Proper" way to tune a 443mhz bpbr Wacom ? S11 with a 50 ohm load at the antenna port? or S21? ? I can "see"? ( and tune ) the notch on S11 , but the notch is

MTR CPS does not run on anything above win XP Chris WB5ITT [email protected]> wrote: