开云体育

Chris, Unfortunately a reboot caused the issue came back :( Its still switching to Active then back to inactive on reciever rx mode. Thanks --Don

The link did not post the first time: https://www.srgclub.org/RF-management.html Thanks, Lloyd for sending me that crazy picture, I would imagine some of the folks will get a laugh out of

Looked. Could not find. Some reason you couldn't have provided a link? Chuck

All, I redid the codeplug from scratch and off it went! Thanks! --Don

I just finished uploading my RF mangement page:? Scroll down to near the bottom for a laugh. -- - Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for the

Chris, other thing too, I looked at the station operation controls and briefly rx mode says active then switches back to inactive. Thanks --Don

Hi Chris, The USB-RIM is set to use an active high signal for both COS and CTCSS. I have the PL line set in the wildcard however I just noticed that there isnt a output for pin C2 in the output group

Greetings all, I have enjoyed reviewing numerous posts on this group over the past several months, especially as I plan and have started a build of a 25W iCOM ID-2010V based mobile repeater on

As promised.... DB4060 Cavity Overspray Article <https://www.repeater-builder.com/antenna/db/db4060-cavity-overspray.html> Kevin W3KKC

This is not confined to amateur installs, I’ve seen some pretty messed up things at commercial sites.

Typo...TKR750 V2 ? wrote:

I've had my TKR751 V2 running 40watts out for 2 years +...put an external fan on it to help but it barely gets warm even tied to the East Coast Reflector! Chris WB5ITT [email protected]> wrote:

At 3/11/2025 08:16 AM, you wrote: At 06:29 AM 3/11/2025, you wrote: >V2's have a number of advantages over non-V2's, not all of which are >important if you're using an external control, but are

<----I disagree. The pre Version 2's didn't have the improved PA design and it was known for PA failures. Not extremely common but they happened. Sure, you could retrofit the new PA board into a pre

I think the isolation is measured from tx to rx port or the other direction with the antenna port terminated. Insertion loss would be one leg to the antenna port.

The replacement piston trimmer cap is a Johanson 5602 1-30 pF 250V. I’ve seen a number of DB4060/4062 cavity sets with a blown trimmer cap. FWIW not an easy cap to source. If you look at the specs

* what is the difference between an 850 and an 851? 25 watts. TKR-850 is 50 watts intermittent, 25 watts continuous duty. TKR-851 is 25 watts continuous, period. Firmware-wise and

Hey Steven, I probably wouldn't spend that much for a used one, maybe offer him 2000 since it says make an offer. I bought mine brand new about a year ago for 3000. I have an extra one in the box that

Yes, they are selling for more than I'm asking on ebay plus shipping. I have to pay for my quantar I just bought from sunny communications or the anritsu andnmy other gear wouldn't be up for sale. I

This is the same one you paid 600 for a few months ago? Matt AL0R Sent: Tuesday, March 11, 2025 07:27 To: [email protected] Subject: [repeater-builder] fs: AnritsuSitemaster S331l