开云体育

writes: The factory board will not decode and encode at same time. Brent, You should just load up your truck and spend the day down here. I have everything to get your box going. Kevin

I tried touching up my duplexers and although the frequency was a bit hard to keep right on, I was able to tune it close. The resulting improvement of my retuning job was very substantial. People

unsubscribe

Hi Henry I have one of the duplexers on one of my repeaters in the network.Check out this site for details or mail them if you have

Ok.....here is a question for everyone. I recently acquired a few Decibel Products UHF bandpass cavities. The model # of them are DB-4021. They are the same as the VHF variety DB-4001, except these

Hi all< Just want to share some web sites where you can get some manuals....I know a lot of you are looking for different manuals and these web sites have a lot of manuals listed for sale...i hope

While spring cleaning I found some photo-copies of the manual for the duplexer I used to use on my repeater. I have 12 professionally copied manuals for Sinclair Duplexers for sale. The manual covers

I am in the process of setting up 2 ge master II's for our local repeater and have some questions about the icoms. One radio will be a link rx only in a environmentally controlled room and the other,

The unit used is 6 months old, yes it does drift a little but if you watch the digital read out, you can get it real close. Bill Tedd Doda wrote:

Tim, RE your crystal problem. The GE Master II was set up for 5 PPM crystals, with the option to use 2 PPM. The way they did this was to install a 5C crystal in channel 1 Receive slot. This unit

Unless the newer ones are better, I found that the VCO drifts too much? I use it for checking the SWR going into the duplexer, but how do you keep it on frequency for a couple minutes at a time while

Steve, sounds like a deal. Send me your snail mail address and I will get a check or money order in the mail asap. Barry, KB6DJT Steven White wrote:

manuls. Thanks I have 5 photo-copies of the Mastr Exec II VHF high-band radios, they are unbound, not even cut right, or anything. I made a few copies of my manual last year before I sold the

Barry, Call GE. 800-446-7649 John Lloyd, K7JL number1bear@... wrote:

the manuls. Thanks You might want to start at the source. The last one I got was free. Check out my site for the details. Look under 'Manuals'

MW, What boards are you looking for??? John Lloyd, K7JL Utah VHF Society m.w.dolan@... wrote:

David, Did your clock reset to 1995? You sent your email as a message from 1995. Back in time? You can order manuals direct from GE. They have a 800 number for publications. 800-446-7649. Tech

Well, one would think that all was working as it should.... except for the fact that the other antenna appears to outperform it. I am assuming it is the same feedline, so that we can rule out some

Tim, Make sure you use a 5C element in the receiver. That is compensated at 5 parts per million. If you are using a mobile, then you need to use one 5C in the RX and an EC in the TX I have had

I am looking for a manual for the Master Exec II VHF mobile radios. I bought a bunch from the Forest Service but now they can't seem to find the manuls. Thanks Barry, KB6DJT