开云体育

Hi All, I have several Mitrek VHF radios I would like to convert to repeaters. I have searched the NET, and have found 3 different version of the conversion instructions. I am sure out of

In a message dated 3/23/1999 4:59:54 PM Eastern Standard Time, patrickn@... writes: << Hello, I have a repeater system consisting of a Yaesu VXR5000 UHF repeate and a Computer

if you will contact gene diehl telephone 219 495 5715 he will sell you a complete master II for 45 dollars plus shipping which will have everything you would need to repair yours for a long time. he

i have a motorola commander series model L1474A remote consel and would like to hook it up to my GE master II low band Base can any body out there help ? and in what refrence would the control

I have done maratrac's with the m 400 software and no special keystrokes were required to take them into the ham bands just direct entry. tom n8ies Jim Horvat wrote:

Are the Red/Black wires still connected to the TX relay at the antenna connector? They should be cut. mch wrote:

Then Joe Orrico WB6HRO wrote: But how would a receiver connected to an IFR differ in voltage from a receiver connected to a duplexer? In case I gave the wrong impression, the unit is still at the

There are jumper changes when you install/uninstall a CTCSS board. I know one is on the front/left side of the system board (with the handle facing you). That is the PTT control jumper that selects

the squelch circut is all ready there. you merely need to put in a pot to set it 73 ed n4ale look at the ge page on the internet and it will tell you where and how.

This is a mobile Mastr II, low band 48mhz. I have the control head, and the squelch control changes a voltage on the plug in panel test point, but the receiver stays un squelched. I am assuming

you can purchase one or build your own take a look at the NHRC web page under master II info http://www.nhrc.net Ed Bathgate RMA Repair Dept x8785 wrote:

If you mean a squelch operated relay, it was an option on the base units. You can hear that relay trip hundreds of feet away from the unit. If you mean an internal (to the drawer unit) squelch, I

Is a squelch circuit an option on a GE Mastr II? Is it a module? Is there a way to build one? 73 Ed N3SDO Ed Bathgate RMA Dept (724) 772-8785 pager (412) 649-6773

Can some one tell me the Key strokes to take the Motorola M 4oo software out of band so I can program the Ham freqs. Thanks Jim W8WRP

All subscribers, Please be advised of the scheduled down time tonight. Kevin Custer W3KKC List Owner From: ONElist Tech Support Hello, The ONElist system will be down for scheduled maintenance

that you I use a Hamtronics R-220 receiver here on my 224.66Mhz repeater and it works OK. But, just OK, nothing special. You also have to remember that it is located here at my house and does not

-- One more quick thing on a Mitrek. I have one on 440 I duplexed that is deaf as a stump until the TX comes up. Then, the sensitivity is great! As soon as the tail drops, it goes back to being deaf.

Hi Chuk As you can see from the date,I am behind in my e-mail but I agree. best 73 Ted Chukgleasn@... wrote:

From: Chukgleasn@... OK, everyone, where are the real RF Hackers? Here's the challenge: Develop some new ways to build 220MHz repeaters. Well Chuk there are several things that don't make

Chukgleasn@... wrote: I believe that would be the Delta, Delta-S, then Delta-SX (those are respectively crystal controlled, synthesized and wideband synthesized units) The -S would obviously be a