开云体育

Hello, Can this repeater reach close to 368 Mhz?

Another way to look at it, most of the time your repeater will be much closer to being on frequency than most of your user radios. There will be enough tolerance that no one will know the

A Quantar high stability oscillator would allow a VHF repeater to go for a very long time without having to adjust back on frequency. The stock osc in a VHF Quantar is pretty good and should go maybe

Or HamVOIP or IRLP or most any kind of link that is not your own. Mick - W7CAT

Sending IDs, courtesy times, etc. down all-star is big no no..... The uplink would also have to be legally IDed in the US under part 97 rules Chris WB5ITT (TARRA) via groups.io

And hang times... So you set up the repeater to transmit PL only during active receive. The COR drops, the tone stops, and the CT, ID and hang time are now invisible to the Allstar

A few more questions on this topic. 1. Understanding the High Stability Oscillator module is used mostly (or perhaps exclusively - not sure) with the 900 MHz Quantars.? Are they of any benefit on

Not quite so simple. You need to get rid of the repeater IDs and any courtesy tones. Mick - W7CAT

Attached is a document I put together many years ago, which outlines how I successfully replaced R100 EEproms, back in the day. I built a EProm programmer called "Pony Prog", I found described on the

Understood.? Thanks!

Oops I got it backwards, going from R2 to R1 will be easy, no complaints when entering 2m frequencies and no VCO problems.

Yes but you need to read the station with CPS, change the receive to band 2 then probably write in the frequencies as they will be erased when changing bands. It will complain if you are entering 2m

If AllStar is all you want to accomplish, you could just set up an AllStar node and set it to TX on your repeater's receive frequency and RX on your repeater's transmit frequency, just like how you

Friends, I have a Quantar that has VHF R2 modules.? I would like to try a VHF R1 Module in it.? Seems unlikely, but is it as simple as powering down and swapping the modules? Thanks! Jeff KC8VFN

An acquaintance has a few GM300s as control receivers on his repeaters (MTR and Quantar). He used to haul around a Toughbook for radio programming and a Toshiba laptop that booted into MS-DOS just for

Pinari, I'm going back decades here, but this is what I remember: As others have pointed out, the R100 repeater is based on European mobiles that have much in common with (but are not identical to)

Or you can buy the Northcomm plug in controller and select up to 15 channels remotely via DTMF.

Wire a 16ch BCD switch to inputs 1 through 4 on the 50 pin and I forget if the switch grounds them or if you pull them high but I can check if needed. Then you need some wildcard instructions to tell

Channel selection on my MSF5000 station is easily accomplished from the from panel, but that does not seem to be the case on a Quantar.? How is it done? Thanks! Jeff KC8VFN

Hi Chris, I was thinking about buying one, but it isn't' clear to me now that there would any value added for a VHF station (which is all I have).? It seems like the Quantar instructions manual I