开云体育

Hi, I don't actually have a copy of that. Chad Nelson WI9HF/WRPL979 Janesville Wisconsin 608-754-8671 Send from my spectrum iPhone 16.

Chad, Try with W7 if you have a copy! it may find the good driver itself. W7 was an XP Updated if i remember! gervais,ve2ckn ________________________________ De : [email protected]

Hi, Does anyone know of a good resource to find WIN XP drivers for RT Systems cables? Tried their web site, however all options for downloads are not available. Thanks, Chad WI9HF

Even in Flat audio mode, the TX side begins to hard rolloff at about 2600 hz. At 3000 you're down 3db and it drops quickly from there. No external filters are needed. It's flat from 20-2600. Andy WJ9J

I've discovered that the RKR1225 / Specta series radio RSS setting allows you to select "post" or "pre" limiting for the TX audio path for flat inputs on the accessory port. Not familiar with the

Yes, reduce the notch depth of the 144.61 c2037. ?If you do want to tx on the 144.39, then you will need at least 2 Q cans on the 144.39 equipment side and 3 Q cans on the 144.61 to notch out each

The flat IOs are for data use....to use the tx flat input for voice, it needs to be limited and filtered externally to prevent overshoot of deviation and bandwidth on squelch noise / noisy signals. I

Sorry,? I found "External Accessories" in the menu. Within the configuration window, I found "Rx Audio Output" was set to "De-emphasized". I changed it to "Flat" and that provided flat audio from the

Privileged info Mick Might cost a nickel of two Are you prepared? queue in THE GREEN DOOR by Jim Lowe 1956 John VK4JKL

But that doesn't tell what you found. Mick - W7CAT

Ahhhhh, I found it! Thanks all! Jim

The "FLAT/EIA" setting is a Radio Wide Configuration feature. Each channel has provisions for bandwidth and deviation, but nothing for De-emphasis/pre-emphasis. Jim

Here is some info from my notes: You have to set each channel to flat audio (I cannot confirm this at the moment) Make sure you set in accessories TX Flat to Pre limiter for best response. Good luck.

IIRC, there are a few boxes you have to correctly set the audio. I ran into the same issue first time I did an R1225. Andy (TARRA) via groups.io <tarra@...> wrote:

I didnt explain it very well. In order of appearance from the antenna: 1. 144.610 rx? ? ? ? ? ? ? ? ? ? ?c2037 2. highband vhf rx? ? ? ? ? ? c2037 3. 145.210 tx? ? ? ? ? ? ? ?

He did say "the "flat audio" check box enabled in the RSS software.". Mick - W7CAT

You have to change it in CPS. Show the screenshots from CPS, then we can help. Thanks Andy WJ9J [email protected]> wrote:

Good Day All, Just reaching out to see if anyone has had any issues with Motorola RKR1225 repeaters not producing flat audio on pin 11 of the accessory port with the "flat audio" check box enabled in

Ya I had seen that one and it was tempting, 6-7 hour drive for me. Kory Links: ------ [1] /g/repeater-builder/message/215400 [2] /mt/103940517/6175112 [3]

All, I am looking for 1-2 Micor Mobiles and/or 1-2 GE Mastr II mobiles potentioally a station if the price is right and its close etc. I am looking for 100-110w radios, on UHF 450-470mhz.? Please