On Fri, May 23, 2025 at 02:00 PM, Chris Boone WB5ITT wrote:
Mike I'm not sure why you did all that. I don't understand what you're trying to do. The SLR 8000 will not send PL during the IDs if you have the correct checkbox marked. I guess it's because you're using an external controller. Are you having the RC 210 do that, send the IDs? Why don't you post your code plug and I'll take a look at it.
?
Chris WB5ITT?
Going to try this again since my other topic was hijacked and turned into a cryfest over ID's..
So, again, RC-210 to a SLR-8000 no TS64. Everything works great, but I am attempting to set up the repeater so that the CW ID does not send PL Tone. (This is our choice, do not start your crying about ID in here) This is how our old config (VXR-7000 with TS64) was set up. Nothing has changed regarding controller programming yet.
My thinking was tying the CTCSS Control pin to GPIO and enabled Tx PL Inhibit would do this just fine. However when I have Tx PL Inhibit programed in, whether set for Active High or Active Low, it strips PL constantly. Is there something I am missing regarding the CTCSS Control output or the way the Tx PL Inhibit function works? Or is there something silly I'm missing on the RC-210 to change the CTCSS Control functionality?
(Please, for the love of god, keep the ID fight out of here)
Mike
Yes, the controller is handling it. We use CWID every 10 minutes and a voice ID at the top of the hour as a "grandfather clock". Would like to keep it that way. I know the repeater will strip it when in repeat mode, but we need the RC210 for interfacing to Allstar and remote base.
Mike
