¿ªÔÆÌåÓý

Mike I'm not sure why you did all that. I don't understand what you're trying to do. The SLR 8000 will not send PL during the IDs if you have the correct checkbox marked. I guess it's because you're using an external controller. Are you having the RC 210 do that, send the IDs? Why don't you post your code plug and I'll take a look at it.

Chris WB5ITT?

On Fri, May 23, 2025, 12:55?€?PM Mike Sullivan via <Kn4imu=[email protected] > wrote:

Going to try this again since my other topic was hijacked and turned into a cryfest over ID's..

So, again, RC-210 to a SLR-8000 no TS64. Everything works great, but I am attempting to set up the repeater so that the CW ID does not send PL Tone. (This is our choice, do not start your crying about ID in here) This is how our old config (VXR-7000 with TS64) was set up. Nothing has changed regarding controller programming yet.

My thinking was tying the CTCSS Control pin to GPIO and enabled Tx PL Inhibit would do this just fine. However when I have Tx PL Inhibit programed in, whether set for Active High or Active Low, it strips PL constantly. Is there something I am missing regarding the CTCSS Control output or the way the Tx PL Inhibit function works? Or is there something silly I'm missing on the RC-210 to change the CTCSS Control functionality?

(Please, for the love of god, keep the ID fight out of here)

Mike


------------------------------------------------------------------------------
President and CTO - Arcom Controllers
Makers of repeater controllers and accessories
Phone: (503) 678 6182
Authorized Dealers for Kenwood and Telewave.
We offer complete turn-key repeater packages!
"We don't just make 'em. We use 'em!"