开云体育

Stan, thank-you for your input. As it happens, from the timing of your post I was actually at the same time watching the W2AEW youtube video on calibration where he demonstrated the Correction switch

Oh, and the 'correction' option in the menu is in -newer- nanovna firmware, so if your friends doesn't have it, he doesn't have the latest firmware. So yes, this was a valid question to ask, since

Gareth, This option is simply a switch that turns the calibration on and off. When it is checked, it is on. But the main status is at the left side of the display, along the center-left edge. If

OK, thanks for that reference, but how do I know whether or not the correction is being applied? Is there a status flag? ie, after doing a calibration, do I leave the Correction option alone or

Basically it toggles your calibration off and uses the base cal in the unit. /g/nanovna-users/topic/53015012?20,2,0,0

Larry, what a wonderful message. I don't think this is the place to chat so I'll send you an email. Brian

Off Topic... Brian, I have fond memories of your Antenna modeling program - from back in the day.. I would load parameters and let the computer run all night. I didn't have a co-processor nor could

I've only just found and joined this group and am using a donated VNA for the first time. So I apologise if I am repeating a topic that is hidden deep within the history of this group. In the CAL

Thank you, Thank you… that did the trick. Your help and patience is much appreciated, I learned something today, now if i can just remember it. This technologically challenged old F er really

You must use only the upgrade/verify portion of dfusedemo. If you first used the upload function, you overwrote your firmware file with the content of the nanovna, trashing it before you used it for

Thankyou for your help and especially your patience.. I didn’t realize i needed the H4, but same result.

Please use the firmware for -H4.

So.. i got the driver installed, showed up as “stm device in dfu mode”, stm cube programmer did not recognize the bna but the dfuse demo program did, the “upload action” part of the programer

The version is typically part of the model number on the sticker on the case. The PCB is the same for the MS and SI - only the chip vendor changes.

Thank you, will get back to this later this evening, it did come in a case, if the version is not on there i will check the chip. Will let you know how it goes

From your photo it appears you have a NanoVNA-H4, (the 4 is for the 4" screen) hardware version 4.3, or perhaps a good clone. Did it come in a case, or was it just the card and screen? Most

Don Brant sent me an .s2p file to help test my plotter. It's for an amplifier with several feet of cabling. When I looked at the phase response, I knew I had found a new poster child for the virtues

Device manager just tells me best driver is already installed but all i get is stm bootloader showing up in USB devices

Thanks for the reply, nowhere on the board do i see any reference to ms,si or zk, where should i be looking? Also have installed dfuse demo but running cannot get the correct driver. Looked in the

What firmware are you trying to use? If you are using Hugen79's firmware then pay close attention to the image you downloaded. I ran into a black screen after upgrade as well caused by me mistakingly