开云体育

S21 isn't used in your antenna tuning context. You can turn off this trace to avoid confusion, unless you like the "modern art" it produces on the screen. The USB C port doesn't need to speak "To-Go"

Answer: YES. When the range changes, calibration must be performed. The number of calibration / measurement points is 101 on the basic unit. 73, Gyula HA3HZ -- *** read more on this site (

Your photo shows S21 phase on the display. This is the phase of the (weak) S21 leakage. If you change it to magnitude, you will see the leakage signal strength. When using the VNA as an antenna

Recalibrate. The number of calibration points is limited. w.

Hello all, Quick question please. If I calibrate my nano from 1Mhz to 900Mhz and I want to change my frequency to 7Mhz to 71Mhz do i have to calibrate again or is this still in range of the original

Are you aware there is a -F variant specific group? Regarding S21 have you made a SOLT calibration in the frequency range of interest? A ter?a, 2/06/2020, 19:52, <wsanders@...> escreveu:

I am using the NanoVNA-F to tune a 75m mobile antenna (see picture.) There is an interesting pattern on the S21 trace. The VNA has been calibrated only using SOL (short-open-load). I have S21 "capped"

[email protected]> wrote: That's not the whole story. A Touchstone file can store data in other formats too - Y, Z, G or H parameters. However, S parameters is the most common. I would be interested

Does all of this mean that the RL on the NanoVNA and VNA Saver are wrong and should be positive??Deon

Herb, Thank you for your message and? explanations for use above 300 Mhz. Most of time, i use the VNA from 1.8 to 146 MHz but sometimes until 440 MHz. For this reason, i will follow your

BTW, I created a guide for nanoVNA users to use QUCS here https://hexandflex.com/2020/01/11/impedance-matching-with-qucs-studio-and-vna/

QUCS studio has a simulation block that accepts Touchstone files. It's the closest free software to ADS. I suspect you can also load them into the free demo CopperMountain VNA software.

Here are some tips for those that may wish to duplicate this box design which has a front panel size of 92mm x 38mm: - The hole centers for the two end connectors, "L" & "THRU" are 15mm from the ends.

GIT is not recognised by many distros until you install it. Zorin is based on Ubuntu so try: sudo apt install git

Hi! I am new in Linux and use Zorin OS 15. I tried to install NanoVNA-Saver, but git command is not recognized at terminal. Python is installed. Is there any tutorial available about installing on

I would like to see a DarkMode version of NanoVNASaver I adjusted the Chart Colors, but there are no options for adjusting the control background colors

Thanks, Alan - wonderful source ! I love it. You made my day! Congrats for having shown this. I can only agree. From it's second very basic formula, (when leaving alone the '(db)',) it is possible to

One additional observation: If I pause the sweep and select the CW freq, there is no output until I un-pause the sweep. However, I can then pause the sweep again and the output remains on.

Hi Herb, I contacted R&L about buying and shipping a Nanovna-H4 to Canada.They sell the H4 for $60US but they quoted me $30US for USPS shipping to Toronto which sounds way too high. Needless to say, I

Rudi, I don't understand the problem you are having with your nanovna-H. I have a current version of firmware on my nanovna and under the stimulus menu, there is "CW FREQ" The nanovna generates a