I just changed it to Version 7 as I found the wheel selector to be quite cramped so I opened the access window up in the newer Version 7. Discard 6 if you downloaded it but haven't printed it yet. I did think, as an afterthought of putting some holes in those corner buffers for the sma calibration caps but thought I might be spoiling everyone. No seriously, FDM printers, the kinds with spools of filament aren't very precise and holes need infill that must be removed at some point, unless they are facing up. You never end up with anything really clean. I think that chances of getting a decent hole for the caps is rather slim and if they fail, there goes your calibration tools.
________________________________
From:
[email protected] <
[email protected]> on behalf of Dan Reynolds <on30ng@...>
Sent: February 25, 2020 6:19 PM
To:
[email protected] <
[email protected]>
Subject: Re: [nanovna-users] 3D Printable Case
I really like this - great job. Would be cool with some plastic SMA's on it to store your protection 'caps' too...
Thanks.
--
Dan Reynolds KB9JLO
Central IL, USA
