开云体育

Hello Ryan, Our time zones have delayed my reply sorry. Go to Menu/your radio/Hardware. On the RHS half way down is the setting "Enable power amp" which should be set to "True". Hopefully this will be

Graeme, i do not remember a setting for that I have been through them now so many times??♂?. ?I will look again. ?Any hints where that setting is? When I hit ptt or spot the relay for my

Hi Ryan, Have you checked that the PA is enabled in the hardware settings? 73, Graeme ZL2APV [email protected]> wrote:

I have quisk running on an old laptop running linux mint 21.? I have a peaberry (now omnia) radio setup working nicely in receive.? Audio sounds good no dropout or anything.? Problem is I cannot

Hello group, I have been working on my remote over the internet and have run into some mysteries. To test my path to the Quisk-remote software I have been trying to telnet? nn.nn.nn.nn port

I normally use "pip3" instead of "pip" but this may only be of concern if you have python2 along with python3 on your machine.

Hi Jim, For some reason this message was kept as draft, I wrote it a week ago... I modified a file from Ben at the Control Head end, and got sample rate working, as well as audio. Only the large

Quisk is easy to install on MacOS using Homebrew. brew install [email protected] fftw portaudio pulseaudio sudo -H python3.9 -m pip install --upgrade quisk Run: python3.9 -m quisk 73, Jim N7IHQ

Thanks for clarifying ... and that is pretty consistent with my experience, using Quisk over network *or* just locally (no remote feature) ... I'm pretty sure this could vary some from computer to

I meant the Play latency , as specified in the "Timing and CW" Tab. 73s, Peter, PA3BIY

Thanks for the good report!? Glad things are working for you. Which "buffer delay" do you mean? -- Ben, AC2YD --

Correction: 50 ms is Okay, 20 ms buffer is NOT!

Hi Ben et al, So there are several (UDP) ports open at 4G in the Netherlands. Among them UDP port 1194, which is used by openvpn. Over the past days I installed openvpn as a server on the odroid XU4

Hi Ben, I've found the reason why I can't connect over a MiFi: limited port access. The 4G providers here make only very few ports available (open), hence I will have to use some kind of tunnel.

Hello Peter, Are you using the latest Quisk?? I recently did some work on the network connection aspects (especially the "already in progress" issue); Jim released that work in the latest, 4.2.12. If

Programming_the_FPGA.txt is the easiest way, much easier than trying to use the GUI. 73 ... Sid.

Thank you. That should do it.

Any cheap USB-Blaster clone will do. You will have to make up an adapter cable as shown in the picture. -- Sid Boyce ... Hamradio License G3VBV, Licensed Private Pilot Emeritus IBM/Amdahl Mainframes

Hi Ben, It seems that all my ports are closed, in spite of the port forwarding. At least that explains why it does not work, not the "Why" they are closed. 73 Peter Op 25/11/2022 om 23:39 schreef Ben

Hi Ben, Yes, PW is set on both devices. The remote and local are both sitting on my desk, so initially I connected them to the LAN, and it worked. Next I connected the Remote to the MIFI and set the